Re: [net-next RFC PATCH 03/14] dt-bindings: net: document ethernet PHY package nodes

[Jie Luo <quic_luoj@quicinc.com>]

On 11/24/2023 3:33 AM, Christian Marangi wrote:
> On Thu, Nov 23, 2023 at 03:57:58PM +0100, Andrew Lunn wrote:
>> On Thu, Nov 23, 2023 at 02:35:31PM +0000, Russell King (Oracle) wrote:
>>> On Thu, Nov 23, 2023 at 03:27:05PM +0100, Andrew Lunn wrote:
>>>>> Just to be more precise qca807x can operate in 3 different mode:
>>>>> (this is controlled by the MODE_CFG bits)
>>>>
>>>>> - QSGMII: 5 copper port
>>>>
>>>> 4 slots over QSGMII, plus the second SERDES is connected to the MAC
>>>> using SGMII/1000BaseX?
>>>>
>>>>> - PSGMII: 5 copper port
>>>>
>>>> 5 slots over QSGMII, the second SERDES is idle?
>>>>
>>>>> - PSGMII: 4 copper port + 1 combo (that can be both fiber or copper)
>>>>
>>>> 5 slots over QSGMII, with the second SERDES connected to an SFP cage.
>>>>
>>>> Are ports 1-4 always connected to the P/Q SGMII. Its only port 5 which
>>>> can use the second SERDES?
>>>
>>> I think what would really help here is if there was an ascii table to
>>> describe the configurations, rather than trying to put it into words.
>>
>> Yes.
>>
>> And also for ipq4019. We need to merge these two threads of
>> conversation, since in the end they are probably the same driver, same
>> device tree etc.
>>
> 
> For everyone that missed Robert response in patch 12 let me quote him
> also here.
> 
> "
> Hi Andrew,
> I think that the description is confusing.
> QCA807x supports 3 different modes:
> 1. PSGMII (5 copper ports)
> 2. PSGMII (4 copper ports + 1 combo port)
> 3. QSGMII+SGMII
> 
> So, in case option 2 is selected then the combo port can also be used for
> 1000Base-X and 100Base-FX modules or copper and it will autodetect the
> exact media.
> This is supported via the SFP op-s and I have been using it without issues
> for a while.
> 
> I have not tested option 3 in combination with SFP to the copper
> module so I cant
> say whether that works.

For the option3, the last PHY works on SGMII mode, then it can't be
used with SFP, only copper is supported in this mode.

>  From what I can gather from the typical usage examples in the
> datasheet, this QSMII+SGMII
> mode is basically intended as a backward compatibility thing as only
> QCA SoC-s have PSGMII
> support so that you could still use SoC-s with QSGMII and SGMII support only.
> 
> So there is no way to control the SerDes-es individually, only the
> global mode can be changed via
> the Chip configuration register in the Combo port.
> 
> You can see the block diagram of this PHY in this public PDF on page 2[1].
> 
> [1] https://content.codico.com/fileadmin/media/download/datasheets/qualcomm/qualcomm_qca8075.pdf
> "
>