Re: [PATCH v4 2/3] bus: mhi: host: Add name for mhi_controller

[Jeffrey Hugo <quic_jhugo@quicinc.com>]

On 6/30/2024 8:12 PM, Slark Xiao wrote:
> For SDX72 MBIM mode, it starts data mux id from 112 instead of 0.
> This would lead to device can't ping outside successfully.
> Also MBIM side would report "bad packet session (112)".In order to
> fix this issue, we decide to use the device name of MHI controller
> to do a match in client driver side. Then client driver could set
> a corresponding mux_id value for this MHI product.
> 
> Signed-off-by: Slark Xiao <slark_xiao@163.com>
> +++ b/include/linux/mhi.h
> @@ -289,6 +289,7 @@ struct mhi_controller_config {
>   };
>   
>   /**
> + * @name: device name of the MHI controller

This needs to be below the next line

>    * struct mhi_controller - Master MHI controller structure
>    * @cntrl_dev: Pointer to the struct device of physical bus acting as the MHI
>    *            controller (required)
> @@ -367,6 +368,7 @@ struct mhi_controller_config {
>    * they can be populated depending on the usecase.
>    */
>   struct mhi_controller {
> +	const char *name;
>   	struct device *cntrl_dev;
>   	struct mhi_device *mhi_dev;
>   	struct dentry *debugfs_dentry;