Re: [PATCH 1/2] MSM: Add USB suport for QSD8x50

[Pavan Kondeti <pkondeti@codeaurora.org>]

Hi Greg,

On 12/15/2010 10:47 PM, Greg KH wrote:
>>> On 12/8/2010 1:37 PM, Pavankumar Kondeti wrote:
>>>> > > > OTG driver takes care of putting hardware into low power mode.  Hence
>>>> > > > make peripheral and host devices as children of OTG device and let
>>>> > > > runtime PM takes care of notifying peripheral and host state to
>>>> > > > OTG device.  VBUS power up and shutdown routines are implemented by
>>>> > > > modem processor.  As RPC infrastructure is not available, configure
>>>> > > > USB in peripheral only mode.
>>>> > > > 
>>>> > > > Signed-off-by: Pavankumar Kondeti <pkondeti@codeaurora.org>
>>>> > > > ---
>>>> > > > This patch depends on [PATCH V3 00/11] Add MSM USB controller driver
>>>> > > > patch series which is under review.
>>> > > 
>>> > > USB driver patches are taken into Greg KH usb-next tree. Is it possible
>>> > > to include this patch for 2.6.38?
>> > 
>> > I don't control Greg's tree, so I don't know what his policies are
>> > regarding patch acceptance ..
> They are like any other patch acceptance rules, what specifically is the
> issue here?

The board support patches ( [PATCH 1/2] MSM: Add USB suport for QSD8x50)
are dependent on USB OTG driver patches ([PATCH V3 00/11] Add MSM USB
controller driver). The USB OTG driver patches are in your
usb-next tree. Where should board support patches go? MSM tree/ USB tree?

Thanks in advance,
Pavan

-- 
Sent by a consultant of the Qualcomm Innovation Center, Inc.
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum.