From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: from wolverine02.qualcomm.com ([199.106.114.251]:2335 "EHLO wolverine02.qualcomm.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1755922Ab0LPDlq (ORCPT ); Wed, 15 Dec 2010 22:41:46 -0500 Message-ID: <4D098A76.80909@codeaurora.org> Date: Thu, 16 Dec 2010 09:11:42 +0530 From: Pavan Kondeti MIME-Version: 1.0 Subject: Re: [PATCH 1/2] MSM: Add USB suport for QSD8x50 References: <1291795628-31054-1-git-send-email-pkondeti@codeaurora.org> <4D06E73E.3060201@codeaurora.org> <1292424098.14253.0.camel@m0nster> <20101215171738.GB1896@kroah.com> In-Reply-To: <20101215171738.GB1896@kroah.com> Content-Type: text/plain; charset=ISO-8859-1 Content-Transfer-Encoding: 7bit Sender: linux-arm-msm-owner@vger.kernel.org List-ID: To: Greg KH Cc: Daniel Walker , linux-arm-msm@vger.kernel.org, linux-usb@vger.kernel.org Hi Greg, On 12/15/2010 10:47 PM, Greg KH wrote: >>> On 12/8/2010 1:37 PM, Pavankumar Kondeti wrote: >>>> > > > OTG driver takes care of putting hardware into low power mode. Hence >>>> > > > make peripheral and host devices as children of OTG device and let >>>> > > > runtime PM takes care of notifying peripheral and host state to >>>> > > > OTG device. VBUS power up and shutdown routines are implemented by >>>> > > > modem processor. As RPC infrastructure is not available, configure >>>> > > > USB in peripheral only mode. >>>> > > > >>>> > > > Signed-off-by: Pavankumar Kondeti >>>> > > > --- >>>> > > > This patch depends on [PATCH V3 00/11] Add MSM USB controller driver >>>> > > > patch series which is under review. >>> > > >>> > > USB driver patches are taken into Greg KH usb-next tree. Is it possible >>> > > to include this patch for 2.6.38? >> > >> > I don't control Greg's tree, so I don't know what his policies are >> > regarding patch acceptance .. > They are like any other patch acceptance rules, what specifically is the > issue here? The board support patches ( [PATCH 1/2] MSM: Add USB suport for QSD8x50) are dependent on USB OTG driver patches ([PATCH V3 00/11] Add MSM USB controller driver). The USB OTG driver patches are in your usb-next tree. Where should board support patches go? MSM tree/ USB tree? Thanks in advance, Pavan -- Sent by a consultant of the Qualcomm Innovation Center, Inc. The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum.