Re: [PATCH 3/3] thermal: qcom: tsens: Implement re-initialization workaround quirk

[Bhupesh Sharma <bhupesh.sharma@linaro.org>]

On 7/19/22 4:09 PM, Konrad Dybcio wrote:
> 
> 
> On 18.07.2022 08:34, bhupesh.sharma@linaro.org wrote:
>> Hi Konrad,
>>
>> On 7/15/22 8:26 PM, Konrad Dybcio <konrad.dybcio@somainline.org> wrote:
>>>
>>>
>>> On 1.07.2022 16:58, Bhupesh Sharma wrote:
>>>> Since for some QCoM tsens controllers, its suggested to
>>>> monitor the controller health periodically and in case an
>>>> issue is detected, to re-initialize the tsens controller
>>>> via trustzone, add the support for the same in the
>>>> qcom tsens driver.
>>>>
>>>> Note that Once the tsens controller is reset using scm call,
>>>> all SROT and TM region registers will enter the reset mode.
>>>>
>>>> While all the SROT registers will be re-programmed and
>>>> re-enabled in trustzone prior to the scm call exit, the TM
>>>> region registers will not re-initialized in trustzone and thus
>>>> need to be handled by the tsens driver.
>>>>
>>>> Cc: Amit Kucheria <amitk@kernel.org>
>>>> Cc: Thara Gopinath <thara.gopinath@gmail.com>
>>>> Cc: linux-pm@vger.kernel.org
>>>> Cc: linux-arm-msm@vger.kernel.org
>>>> Signed-off-by: Bhupesh Sharma <bhupesh.sharma@linaro.org>
>>>> Reported-by: kernel test robot <lkp@intel.com>
>>>> ---
>>> Hi, I think this should be also checked and applied on init. This
>>> seems required for at least SM6375, as the controller starts (or
>>> well, doesn't start...) in an unknown state and the driver does
>>> not like it, as the TSENS_EN indicates it is disabled.
>>> Downstream runs this right at probe..
>>
>> Hmm.. very interesting. I was not aware of the SM6375 case, as for SM8150
>> the controller starts in a valid state but may require reinit during operation.
>>
>> So, I did not use the downstream approach to do it right at _probe() and then
>> later while get_temp() is called.
>>
>> Let me add that in v2. BTW do you want me to set the need_reinit_wa as true
>> for SM6375 as well, or would you like to add that with a followup-patch ?
> Please set it, I'll happily test it!

Thanks. Will share v2 shortly.

Regards,
Bhupesh