Re: [PATCH] phy: qcom: Add driver for QCOM APQ8064 SATA PHY

[Srinivas Kandagatla <srinivas.kandagatla@linaro.org>]

On 23/06/14 19:12, Kumar Gala wrote:
>
> On Jun 23, 2014, at 1:00 PM, Srinivas Kandagatla <srinivas.kandagatla@linaro.org> wrote:
>
>> Add a PHY driver for uses with AHCI based SATA controller driver on the
>> APQ8064 family of SoCs.
>>
>> This patch is a forward port plus separating PHY code of SATA driver
>> from Qualcomm's v3.4 andriod kernel.
>>
>> Tested on IFC6410 board.
>>
>> CC: Sujit Reddy Thumma <sthumma@codeaurora.org>
>> Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
>> ---
>> drivers/phy/Kconfig                 |   7 +
>> drivers/phy/Makefile                |   1 +
>> drivers/phy/phy-qcom-apq8064-sata.c | 358 ++++++++++++++++++++++++++++++++++++
>> 3 files changed, 366 insertions(+)
>> create mode 100644 drivers/phy/phy-qcom-apq8064-sata.c
>
> Did you look at the 3.10 Android kernel tree version of the phy driver?
>
No, I did not get a chance to look at it. I will have a look at it today.
> Also do you have a DT binding spec to go with this?
yes, I did add it into the same binding spec qcom-phy.txt as ipq806x.

I will send this in a different patch.

thanks,
srini
>
> - k
>