Re: [PATCH v8 0/3] clk: qcom: clk-rcg2: introduce support for multiple conf for same freq

[Stephen Boyd <sboyd@kernel.org>]

Quoting Kathiravan Thirumoorthy (2024-01-22 09:46:23)
> 
> 
> On 12/21/2023 3:47 AM, Christian Marangi wrote:
> > This small series fix a current problem with ipq8074 where the 2 uniphy
> > port doesn't work in some corner case with some clk configuration. The
> > port to correctly work require a specific frequency, using the wrong one
> > results in the port not transmitting data.
> > 
> > With the current code with a requested freq of 125MHz, the frequency is
> > set to 105MHz. This is caused by the fact that there are 2 different
> > configuration to set 125MHz and it's always selected the first one that
> > results in 105MHz.
> > 
> > In the original QSDK code, the frequency configuration selection is
> > different and the CEIL FLOOR logic is not present. Instead it's used a
> > BEST approach where the frequency table is checked and then it's checked
> > if there are duplicate entry.
> > 
> > This proposed implementation is more specific and introduce an entire new
> > set of ops and a specific freq table to support this special configuration.
> > 
> > A union is introduced in rcg2 struct to not duplicate the struct.
> > A new set of ops clk_rcg2_fm_ops are introduced to support this new kind
> > of frequency table.
> > 
> 
> 
> Bjorn / Stephen Boyd,
> 
> I would like to know if there are any comments on this series. To enable 
> the clocks required for the Ethernet interfaces on the IPQ platforms, 
> these patches are needed. If no concerns, can this be picked up for v6.9?
> 

I'm fine if Bjorn wants to pick it up.

Acked-by: Stephen Boyd <sboyd@kernel.org>