From: Sai Prakash Ranjan <saiprakash.ranjan@codeaurora.org>
To: Mathieu Poirier <mathieu.poirier@linaro.org>
Cc: Suzuki K Poulose <suzuki.poulose@arm.com>,
Mike Leach <mike.leach@linaro.org>,
linux-arm-kernel@lists.infradead.org,
linux-kernel@vger.kernel.org, linux-arm-msm@vger.kernel.org,
coresight@lists.linaro.org, Stephen Boyd <swboyd@chromium.org>,
robin.murphy@arm.com
Subject: Re: [PATCH 2/2] coresight: tmc: Add shutdown callback for TMC ETR/ETF
Date: Tue, 02 Jun 2020 13:00:05 +0530 [thread overview]
Message-ID: <6d759cc28628ea72767c1304883630eb@codeaurora.org> (raw)
In-Reply-To: <20200601212858.GB24287@xps15>
Hi Mathieu,
Thanks for taking your time for review.
On 2020-06-02 02:58, Mathieu Poirier wrote:
> Hi Sai,
>
> On top of the comments already privided by Mike, I have the following:
>
> On Mon, Jun 01, 2020 at 01:32:26PM +0530, Sai Prakash Ranjan wrote:
>> Implement a shutdown callback to ensure ETR/ETF hardware is
>> properly shutdown in reboot/shutdown path. This is required
>> for ETR/ETF which has SMMU address translation enabled like
>> on SC7180 SoC and few others. If the hardware is still accessing
>> memory after SMMU translation is disabled as part of SMMU
>> shutdown callback in system reboot or shutdown path, then
>> IOVAs(I/O virtual address) which it was using will go on the bus
>> as the physical addresses which might result in unknown crashes
>> (NoC/interconnect errors). So we make sure from this shutdown
>> callback that the ETR/ETF is shutdown before SMMU translation is
>> disabled and device_link in SMMU driver will take care of ordering
>> of shutdown callbacks such that SMMU shutdown callback is not
>> called before any of its consumer shutdown callbacks.
>>
>> Signed-off-by: Sai Prakash Ranjan <saiprakash.ranjan@codeaurora.org>
>> ---
>> .../hwtracing/coresight/coresight-tmc-etf.c | 4 +--
>> .../hwtracing/coresight/coresight-tmc-etr.c | 2 +-
>> drivers/hwtracing/coresight/coresight-tmc.c | 29
>> +++++++++++++++++++
>> drivers/hwtracing/coresight/coresight-tmc.h | 3 ++
>> 4 files changed, 35 insertions(+), 3 deletions(-)
>>
>> diff --git a/drivers/hwtracing/coresight/coresight-tmc-etf.c
>> b/drivers/hwtracing/coresight/coresight-tmc-etf.c
>> index 36cce2bfb744..cba3e7592820 100644
>> --- a/drivers/hwtracing/coresight/coresight-tmc-etf.c
>> +++ b/drivers/hwtracing/coresight/coresight-tmc-etf.c
>> @@ -85,7 +85,7 @@ static void __tmc_etb_disable_hw(struct tmc_drvdata
>> *drvdata)
>> CS_LOCK(drvdata->base);
>> }
>>
>> -static void tmc_etb_disable_hw(struct tmc_drvdata *drvdata)
>> +void tmc_etb_disable_hw(struct tmc_drvdata *drvdata)
>> {
>> __tmc_etb_disable_hw(drvdata);
>> coresight_disclaim_device(drvdata->base);
>> @@ -118,7 +118,7 @@ static int tmc_etf_enable_hw(struct tmc_drvdata
>> *drvdata)
>> return 0;
>> }
>>
>> -static void tmc_etf_disable_hw(struct tmc_drvdata *drvdata)
>> +void tmc_etf_disable_hw(struct tmc_drvdata *drvdata)
>> {
>> CS_UNLOCK(drvdata->base);
>>
>
> Why do we care about ETB and ETF when they both use RAM internal to the
> device?
> Moreover, the system RAM they use is not dedicated and as such falls
> back to the
> kernel's memory pool.
>
Actually we don't, I added the disable for ETF/ETB for completeness
since we are
adding shutdown callback for TMC devices and not just ETR although this
issue applies
only for ETR and it doesn't hurt to disable these devices in shutdown
path.
>> diff --git a/drivers/hwtracing/coresight/coresight-tmc-etr.c
>> b/drivers/hwtracing/coresight/coresight-tmc-etr.c
>> index 625882bc8b08..b29c2db94d96 100644
>> --- a/drivers/hwtracing/coresight/coresight-tmc-etr.c
>> +++ b/drivers/hwtracing/coresight/coresight-tmc-etr.c
>> @@ -1110,7 +1110,7 @@ static void __tmc_etr_disable_hw(struct
>> tmc_drvdata *drvdata)
>>
>> }
>>
>> -static void tmc_etr_disable_hw(struct tmc_drvdata *drvdata)
>> +void tmc_etr_disable_hw(struct tmc_drvdata *drvdata)
>> {
>> __tmc_etr_disable_hw(drvdata);
>> /* Disable CATU device if this ETR is connected to one */
>> diff --git a/drivers/hwtracing/coresight/coresight-tmc.c
>> b/drivers/hwtracing/coresight/coresight-tmc.c
>> index 5a271ebc4585..7e687a356fe0 100644
>> --- a/drivers/hwtracing/coresight/coresight-tmc.c
>> +++ b/drivers/hwtracing/coresight/coresight-tmc.c
>> @@ -540,6 +540,34 @@ static int tmc_probe(struct amba_device *adev,
>> const struct amba_id *id)
>> return ret;
>> }
>>
>> +static void tmc_shutdown(struct amba_device *adev)
>> +{
>> + struct tmc_drvdata *drvdata = amba_get_drvdata(adev);
>> +
>> + if (!drvdata->enable)
>> + goto out;
>> +
>> + /*
>> + * We do not care about the active trace sessions here
>> + * since the system is going down unlike remove callback,
>> + * just make sure that the hardware is shutdown.
>> + */
>> + switch (drvdata->config_type) {
>> + case TMC_CONFIG_TYPE_ETB:
>> + tmc_etb_disable_hw(drvdata);
>> + break;
>> + case TMC_CONFIG_TYPE_ETF:
>> + tmc_etf_disable_hw(drvdata);
>> + break;
>> + case TMC_CONFIG_TYPE_ETR:
>> + tmc_etr_disable_hw(drvdata);
>> + }
>> +
>> +out:
>> + misc_deregister(&drvdata->miscdev);
>> + coresight_unregister(drvdata->csdev);
>
> If a session is active when tmc_shutdown() is called, unregistering the
> ETF/ETR
> will result in a kernel crash if the session is stopped before the
> kernel has
> had the opportunity to shutdown. It is the problem as trying to make
> coresight
> drivers modular.
>
> For this to really work the ongoing session would need to be stopped.
> That
> would teardown the path and stop the sink.
I have tested this with and without active trace sessions multiple times
on 2 devices
and did not observe a single crash. The crash should be easily triggered
as per
what you are saying if we have active sessions but I do not see any
crash.
>
> That being said I'm sure that dependencies on an IOMMU isn't a problem
> confined
> to coresight. I am adding Robin Murphy, who added this commit [1], to
> the thread
> in the hope that he can provide guidance on the right way to do this.
>
SMMU/IOMMU won't be able to do much here as it is the client's
responsiblity to
properly shutdown and SMMU device link just makes sure that
SMMU(supplier) shutdown is
called only after its consumers shutdown callbacks are called.
Thanks,
Sai
--
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a
member
of Code Aurora Forum, hosted by The Linux Foundation
next prev parent reply other threads:[~2020-06-02 7:30 UTC|newest]
Thread overview: 29+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-06-01 8:02 [PATCH 0/2] coresight: tmc: Add shutdown callback for TMC ETR/ETF Sai Prakash Ranjan
2020-06-01 8:02 ` [PATCH 1/2] coresight: tmc: Add enable flag to indicate the status of ETR/ETF Sai Prakash Ranjan
2020-06-01 13:27 ` Mike Leach
2020-06-01 17:13 ` Sai Prakash Ranjan
2020-06-01 8:02 ` [PATCH 2/2] coresight: tmc: Add shutdown callback for TMC ETR/ETF Sai Prakash Ranjan
2020-06-01 13:35 ` Mike Leach
2020-06-01 17:15 ` Sai Prakash Ranjan
2020-06-01 21:28 ` Mathieu Poirier
2020-06-02 7:30 ` Sai Prakash Ranjan [this message]
2020-06-02 22:12 ` Mike Leach
2020-06-03 10:24 ` Sai Prakash Ranjan
2020-06-03 11:27 ` Mike Leach
2020-06-03 12:14 ` Sai Prakash Ranjan
2020-06-03 13:22 ` Mike Leach
2020-06-03 13:34 ` Robin Murphy
2020-06-03 13:43 ` Sai Prakash Ranjan
2020-06-03 13:51 ` Mike Leach
2020-06-03 14:02 ` Sai Prakash Ranjan
2020-06-03 17:44 ` Mathieu Poirier
2020-06-04 7:27 ` Sai Prakash Ranjan
2020-06-08 14:07 ` Sai Prakash Ranjan
2020-06-09 15:27 ` Mathieu Poirier
2020-06-09 15:37 ` Sai Prakash Ranjan
2020-06-03 11:37 ` Robin Murphy
2020-06-03 12:00 ` Sai Prakash Ranjan
2020-06-03 12:21 ` Robin Murphy
2020-06-03 12:26 ` Sai Prakash Ranjan
2020-06-03 13:40 ` Robin Murphy
2020-06-03 13:51 ` Sai Prakash Ranjan
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=6d759cc28628ea72767c1304883630eb@codeaurora.org \
--to=saiprakash.ranjan@codeaurora.org \
--cc=coresight@lists.linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=mathieu.poirier@linaro.org \
--cc=mike.leach@linaro.org \
--cc=robin.murphy@arm.com \
--cc=suzuki.poulose@arm.com \
--cc=swboyd@chromium.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).