Re: [RFC PATCH 4/6] drm/msm/dsi: Use DSC slice(s) packet size to compute word count

[Abhinav Kumar <quic_abhinavk@quicinc.com>]

On 12/13/2022 3:22 PM, Marijn Suijten wrote:
> According to downstream the value to use for WORD_COUNT is
> bytes_per_pkt, which denotes the number of bytes in a packet based on
> how many slices have been configured by the panel driver times the
> width of a slice times the number of bytes per pixel.
> 
> The DSC panels seen thus far use one byte per pixel, only one slice
> per packet, and a slice width of half the panel width leading to the
> desired bytes_per_pkt+1 value to be equal to hdisplay/2+1.  This however
> isn't the case anymore for panels that configure two slices per packet,
> where the value should now be hdisplay+1.
> 
> Note that the aforementioned panel (on a Sony Xperia XZ3, sdm845) with
> slice_count=1 has also been tested to successfully accept slice_count=2,
> which would have shown corrupted output previously.
> 
> Fixes: 08802f515c3c ("drm/msm/dsi: Add support for DSC configuration")
> Signed-off-by: Marijn Suijten <marijn.suijten@somainline.org>

Reviewed-by: Abhinav Kumar <quic_abhinavk@quicinc.com>
> ---
>   drivers/gpu/drm/msm/dsi/dsi_host.c | 2 +-
>   1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/drivers/gpu/drm/msm/dsi/dsi_host.c b/drivers/gpu/drm/msm/dsi/dsi_host.c
> index b83cf70b1adb..0686c35a6fd4 100644
> --- a/drivers/gpu/drm/msm/dsi/dsi_host.c
> +++ b/drivers/gpu/drm/msm/dsi/dsi_host.c
> @@ -989,7 +989,7 @@ static void dsi_timing_setup(struct msm_dsi_host *msm_host, bool is_bonded_dsi)
>   		if (!msm_host->dsc)
>   			wc = hdisplay * dsi_get_bpp(msm_host->format) / 8 + 1;
>   		else
> -			wc = mode->hdisplay / 2 + 1;
> +			wc = msm_host->dsc->slice_chunk_size * msm_host->dsc->slice_count + 1;
>   
>   		dsi_write(msm_host, REG_DSI_CMD_MDP_STREAM0_CTRL,
>   			DSI_CMD_MDP_STREAM0_CTRL_WORD_COUNT(wc) |