messages from 2014-05-29 20:44:49 to 2014-06-12 20:06:07 UTC [more...]
[PATCH v2 0/3] Qualcomm Resource Power Manager driver
2014-06-12 20:06 UTC (5+ messages)
` [PATCH v2 1/3] soc: devicetree: bindings: Add Qualcomm RPM DT binding
` [PATCH v2 2/3] soc: qcom-rpm: Driver for the Qualcomm RPM
` [PATCH v2 3/3] regulator: qcom-rpm: Regulator driver "
[PATCH 1/3] ahci-platform: Bump max number of clocks to 5
2014-06-12 19:50 UTC (4+ messages)
` [PATCH 2/3] ata: Add Qualcomm ARM SoC AHCI SATA host controller driver
` [PATCH 3/3] ata: qcom: Add device tree bindings information
[Patch v2 0/3] spi: qup: Fixes and new version support
2014-06-12 19:34 UTC (4+ messages)
` [Patch v2 1/3] spi: qup: Remove chip select function
` [Patch v2 2/3] spi: qup: Fix order of spi_register_master
` [Patch v2 3/3] spi: qup: Add support for v1.1.1
[PATCH 1/2] phy: qcom: Add driver for QCOM IPQ806x SATA PHY
2014-06-12 19:18 UTC (2+ messages)
` [PATCH 2/2] phy: qcom: Add device tree bindings information
[PATCH v1] clk: qcom: Add APQ8084 Multimedia Clock Controller (MMCC) support
2014-06-12 16:41 UTC
[PATCH] mmc: sdhci-msm: Fix fallout from sdhci refactoring
2014-06-12 8:59 UTC (5+ messages)
[PATCH 0/4] spi: qup: Fixes and new version support
2014-06-12 4:02 UTC (4+ messages)
` [PATCH 1/4] spi: qup: Remove chip select function
[PATCH v6 00/12] Qualcomm SD Card Controller support
2014-06-11 17:37 UTC (21+ messages)
` [PATCH v6 01/12] mmc: mmci: use NSEC_PER_SEC macro
` [PATCH v6 02/12] mmc: mmci: Add Qualcomm specific register defines
` [PATCH v6 03/12] mmc: mmci: Add enough delay between writes to CMD register
` [PATCH v6 04/12] mmc: mmci: Add Qcom datactrl register variant
` [PATCH v6 05/12] mmc: mmci: add ddrmode mask to variant data
` [PATCH v6 06/12] mmc: mmci: add 8bit bus support in "
` [PATCH v6 07/12] mmc: mmci: add edge support to data and command out "
` [PATCH v6 08/12] mmc: mmci: Add support to data commands via variant structure
` [PATCH v6 09/12] mmc: mmci: add f_max to "
` [PATCH v6 10/12] mmc: mmci: add explicit clk control
` [PATCH v6 11/12] mmc: mmci: Add Qcom specific rx_fifocnt logic
` [PATCH v6 12/12] mmc: mmci: Add Qualcomm Id to amba id table
[PATCH 0/2] Support apq8064 global clock control
2014-06-11 11:11 UTC (5+ messages)
` [PATCH 1/2] clk: qcom: add clocks necessary for apq8064 sdcc
` [PATCH 2/2] clk: qcom: Fully support apq8064 global clock control
[PATCH] mmc: sdhci-msm: Fix crash due to missing ops functions
2014-06-10 18:49 UTC
[RFC PATCH 0/2] MSM/QCOM: Fix few race conditions when DEBUG_LL is enabled
2014-06-10 17:57 UTC (9+ messages)
` [RFC PATCH 1/2] soc: qcom: do not disable the iface clock in probe
` [RFC PATCH 2/2] tty:msm_serial: Do not reset IP if we use bootconsole
[PATCH] ARM: qcom: select GSBI from mach kconfig
2014-06-10 17:31 UTC (2+ messages)
[PATCH v3 0/3] Add Qualcomm crypto driver
2014-06-10 8:34 UTC (6+ messages)
` [PATCH v3 1/3] crypto: qce: Qualcomm crypto engine driver
` [PATCH v3 2/3] crypto: qce: Build Qualcomm crypto driver
` [PATCH v3 3/3] ARM: DT: qcom: Add Qualcomm crypto driver binding document
[PATCH] drm/msm/hdmi: set hdp clock rate before prepare_enable call
2014-06-09 18:13 UTC (3+ messages)
We offer all purpose loan at 3% interest rate
2014-06-08 22:15 UTC
[PATCH] gpu: drm: msm: Replace type of paddr to uint32_t
2014-06-05 14:49 UTC (5+ messages)
[PATCH V1 0/4] LU queue depth manament
2014-06-05 12:44 UTC (2+ messages)
` [Resend PATCH V1 4/4] scsi: ufs: Fix queue depth handling for best effort cases
[PATCH v5 1/1] usb: gadget: f_fs: Add support for SuperSpeed Mode
2014-06-05 11:32 UTC (6+ messages)
` [RFC] usb: gadget: f_fs: Add flags to descriptors block
` [PATCHv2] "
[PATCH v3] clk: qcom: Add support for IPQ8064's global clock controller (GCC)
2014-06-04 16:19 UTC
[PATCH V1 0/4] LU queue depth manament
2014-06-04 3:31 UTC (9+ messages)
` [PATCH V1 1/4] scsi: ufs: query descriptor API
` [PATCH V1 2/4] scsi: ufs: device query status and size check
` [PATCH V1 3/4] scsi: ufs: Logical Unit (LU) command queue depth
` [PATCH V1 4/4] scsi: ufs: Fix queue depth handling for best effort cases
[PATCH] tty: serial: msm: Fix section mismatch warning
2014-06-03 21:17 UTC (5+ messages)
[PATCH] clk: export __clk_round_rate for providers
2014-06-03 17:37 UTC (2+ messages)
[PATCH v3 0/2] ARM: dts: qcom: Add APQ8084 DT nodes for GCC and UART
2014-06-03 14:29 UTC (3+ messages)
` [PATCH v3 1/2] ARM: dts: qcom: Add APQ8084 Global Clock Controller DT node
` [PATCH v3 2/2] ARM: dts: qcom: Add APQ8084 serial port "
[PATCH v3 0/2] clk: qcom: Add APQ8084 Global Clock Controller support
2014-06-03 14:24 UTC (3+ messages)
` [PATCH v3 1/2] clk: qcom: Add APQ8084 Global Clock Controller documentation
` [PATCH v3 2/2] clk: qcom: Add APQ8084 Global Clock Controller support
[PATCH] of: treat PCI config space as IORESOURCE_MEM type
2014-06-03 11:38 UTC (28+ messages)
` [PATCH 1/2] pci: Add IORESOURCE_BIT entry for PCIe ECAM resources
` [PATCH 2/2] of: treat PCI config space as IORESOURCE_MEM type with special flags
[PATCH] tty: serial: msm_serial.c: Cleaning up uninitialized variables
2014-06-02 23:15 UTC (3+ messages)
[PATCH v2 0/4] clk: qcom: Add APQ8084 Global Clock Controller support
2014-06-02 20:49 UTC (12+ messages)
` [PATCH v2 1/4] clk: qcom: Add APQ8084 Global Clock Controller documentation
` [PATCH v2 2/4] clk: qcom: Add APQ8084 Global Clock Controller support
` [PATCH v2 3/4] ARM: dts: qcom: Add APQ8084 Global Clock Controller DT node
` [PATCH v2 4/4] ARM: dts: qcom: Add APQ8084 serial port "
[PATCH 0/3] Qualcomm Resource Power Manager driver
2014-06-02 10:01 UTC (23+ messages)
` [PATCH 1/3] mfd: devicetree: bindings: Add Qualcomm RPM DT binding
` [PATCH 2/3] mfd: qcom-rpm: Driver for the Qualcomm RPM
` [PATCH 3/3] regulator: qcom-rpm: Regulator driver "
[PATCH v5 00/13] Add Qualcomm SD Card Controller support
2014-06-02 7:12 UTC (18+ messages)
` [PATCH v5 01/13] mmc: mmci: use NSEC_PER_SEC macro
` [PATCH v5 02/13] mmc: mmci: convert register bits to use BIT() macro
` [PATCH v5 03/13] mmc: mmci: Add Qualcomm specific register defines
` [PATCH v5 04/13] mmc: mmci: Add enough delay between writes to CMD register
` [PATCH v5 05/13] mmc: mmci: Add Qcom datactrl register variant
` [PATCH v5 06/13] mmc: mmci: add ddrmode mask to variant data
` [PATCH v5 07/13] mmc: mmci: add 8bit bus support in "
` [PATCH v5 08/13] mmc: mmci: add edge support to data and command out "
` [PATCH v5 09/13] mmc: mmci: Add support to data commands via variant structure
` [PATCH v5 10/13] mmc: mmci: add f_max to "
` [PATCH v5 11/13] mmc: mmci: add explicit clk control
` [PATCH v5 12/13] mmc: mmci: Add Qcom specific rx_fifocnt logic
` [PATCH v5 13/13] mmc: mmci: Add Qualcomm Id to amba id table
[PATCH] net: ks8851: Don't use regulator_get_optional()
2014-06-02 2:48 UTC (3+ messages)
[GIT PULL] qcom driver changes for v3.16-2
2014-05-31 3:58 UTC (5+ messages)
[GIT PULL] qcom SoC changes for v3.16-2
2014-05-31 3:35 UTC (2+ messages)
[GIT PULL] qcom defconfig changes for v3.16-2
2014-05-31 3:34 UTC (2+ messages)
[GIT PULL] qcom DT changes for v3.16-2
2014-05-31 3:33 UTC (2+ messages)
[PATCH] dmaengine: qcom_bam_dma: Add descriptor flags
2014-05-30 20:49 UTC
[PATCH] ARM: qcom: Enable GSBI driver in defconfig
2014-05-30 18:07 UTC (3+ messages)
[PATCH v4 00/13] Add Qualcomm SD Card Controller support
2014-05-30 16:20 UTC (20+ messages)
` [PATCH v4 03/13] mmc: mmci: Add Qualcomm Id to amba id table
` [PATCH v4 06/13] mmc: mmci: add ddrmode mask to variant data
` [PATCH v4 09/13] mmc: mmci: add Qcom specifics of clk and datactrl registers
` [PATCH v4 11/13] mmc: mmci: add f_max to variant structure
` [PATCH v4 12/13] mmc: mmci: add explicit clk control
` [PATCH v4 13/13] mmc: mmci: Add Qcom specific pio_read function
[PATCH v3 00/13] Add Qualcomm SD Card Controller support
2014-05-30 9:00 UTC (7+ messages)
` [PATCH v3 13/13] mmc: mmci: Add Qcom specific pio_read function
[PATCH v2 0/4] Add Qualcomm APQ8084 SoC support
2014-05-30 7:50 UTC (8+ messages)
` [PATCH v2 4/4] ARM: debug: qcom: add UART addresses to Kconfig help
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox