messages from 2014-08-26 12:45:56 to 2014-09-08 10:19:24 UTC [more...]
[PATCH 0/2] Intial support for voltage ADC
2014-09-08 10:19 UTC (6+ messages)
` [PATCH 1/2] iio: vadc: Qualcomm SPMI PMIC voltage ADC driver
` [PATCH 2/2] DT: iio: vadc: document dt binding
[PATCH v5 0/7] QCOM 8074 cpuidle driver
2014-09-08 9:48 UTC (11+ messages)
` [PATCH v5 1/7] msm: scm: Add SCM warmboot flags for quad core targets
` [PATCH v5 2/7] qcom: spm: Add Subsystem Power Manager driver (SAW2)
` [PATCH v5 3/7] qcom: spm-devices: Add SPM device manager for the SoC
` [PATCH v5 4/7] arm: dts: qcom: Add SPM device bindings for 8974
` [PATCH v5 5/7] qcom: msm-pm: Add cpu low power mode functions
` [PATCH v5 6/7] qcom: cpuidle: Add cpuidle driver for QCOM cpus
` [PATCH v5 7/7] arm: dts: qcom: Add idle states device nodes for 8974
[PATCH v2 00/15] Krait clocks + Krait CPUfreq
2014-09-08 9:42 UTC (20+ messages)
` [PATCH v2 01/15] clk: mux: Add unregistration API
` [PATCH v2 02/15] clk: mux: Split out register accessors for reuse
` [PATCH v2 03/15] clk: Add __clk_mux_determine_rate_closest
` [PATCH v2 04/15] clk: divider: Make generic for usage elsewhere
` [PATCH v2 05/15] clk: Add safe switch hook
` [PATCH v2 06/15] clk: Avoid sending high rates to downstream clocks during set_rate
` [PATCH v2 07/15] clk: qcom: Add support for High-Frequency PLLs (HFPLLs)
` [PATCH v2 08/15] clk: qcom: Add HFPLL driver
` [PATCH v2 09/15] clk: qcom: Add MSM8960/APQ8064's HFPLLs
` [PATCH v2 10/15] clk: qcom: Add IPQ806X's HFPLLs
` [PATCH v2 11/15] clk: qcom: Add support for Krait clocks
` [PATCH v2 12/15] clk: qcom: Add KPSS ACC/GCC driver
` [PATCH v2 13/15] clk: qcom: Add Krait clock controller driver
` [PATCH v2 14/15] cpufreq: Add module to register cpufreq on Krait CPUs
` [PATCH v2 15/15] ARM: dts: qcom: Add necessary DT data for Krait cpufreq
[PATCH v4 1/2] timer: provide an api for deferrable timeout
2014-09-08 9:39 UTC (7+ messages)
` [PATCH v4 2/2] ksm: provide support to use deferrable timers for scanner thread
[PATCH v9 2/6] clk: Move all drivers to use internal API
2014-09-08 6:13 UTC (2+ messages)
[PATCH] dmaengine: qcom_bam_dma: add one more optional clock
2014-09-07 17:55 UTC
use IORESOURCE_REG resource type for non-translatable addresses in DT
2014-09-05 23:29 UTC (14+ messages)
` [PATCH] RFC: add function for localbus address
[PATCH] ARM: debug: Update MSM and QCOM DEBUG_LL help
2014-09-05 22:51 UTC
[PATCH v3] ARM: dts: qcom: Add initial IFC6540 board device tree
2014-09-05 16:00 UTC (5+ messages)
[PATCH] ARM: msm: Update the references to DEBUG_MSM_UARTx
2014-09-05 7:23 UTC (5+ messages)
` [PATCH v2] "
[PATCH v4 0/4] pinctrl: qcom: Add APQ8084 pinctrl support
2014-09-05 7:20 UTC (10+ messages)
` [PATCH v4 1/4] "
` [PATCH v4 2/4] dt: Document Qualcomm APQ8084 pinctrl binding
` [PATCH v4 3/4] ARM: dts: qcom: Add TLMM DT node for APQ8084
` [PATCH v4 4/4] pinctrl: qcom: Make the target processor value configurable
Status of chipidea msm USB reset patch
2014-09-05 1:01 UTC (8+ messages)
` Fwd: "
[PATCH] genirq: Introduce irq_read_line()
2014-09-05 0:14 UTC (2+ messages)
[PATCH] mmc: sdhci-msm: Make tuning block table endian agnostic
2014-09-04 22:01 UTC (6+ messages)
[PATCH] clk: qcom: Consolidate frequency finding logic
2014-09-04 21:11 UTC
[PATCH v2 0/4] Use wound/wait mutexes in the common clock framework
2014-09-04 1:01 UTC (5+ messages)
` [PATCH v2 1/4] clk: Recalc rate and accuracy in underscore functions if not caching
` [PATCH v2 2/4] clk: Make __clk_lookup() use a list instead of tree search
` [PATCH v2 3/4] clk: Use lockless functions for debug printing
` [PATCH v2 4/4] clk: Use ww_mutexes for clk_prepare_{lock/unlock}
FROM: Husam Al Sayed
2014-09-03 18:24 UTC
[PATCH v3] hwspinlock: qcom: Add support for Qualcomm HW Mutex block
2014-09-03 16:34 UTC (6+ messages)
[PATCH] mmc: sdhci-msm: Make tuning block table endian agnostic
2014-09-03 13:37 UTC (4+ messages)
[PATCH/RFC V2 00/16] UFS: Power managment support
2014-09-03 13:04 UTC (6+ messages)
` [PATCH/RFC V2 10/16] scsi: ufs: add UFS power management support
[PATCH v8 3/7] clk: Move all drivers to use internal API
2014-09-03 12:59 UTC (3+ messages)
[PATCH] clk: qcom: Fix sdc 144kHz frequency entry
2014-09-02 23:52 UTC (4+ messages)
[PATCH] msm: scm: Move scm-boot files to drivers/soc and include/soc
2014-09-02 19:44 UTC
[PATCH v2] hwspinlock/msm: Add support for Qualcomm MSM HW Mutex block
2014-09-02 18:48 UTC (6+ messages)
[PATCH v3 0/4] Add reset support for apq8064
2014-09-02 17:06 UTC (10+ messages)
` [PATCH v3 1/4] ARM: DT: APQ8064: Add pinctrl support
` [PATCH v3 2/4] ARM: DT: APQ8064: Add node for ps_hold function in pinctrl
` [PATCH v3 3/4] pinctrl: msm: Add ps_hold function in pinctrl-apq8064 binding documentation
` [PATCH v3 4/4] pinctrl: qcom: Add support for reset for apq8064
[PATCH v3 0/4] pinctrl: qcom: Add APQ8084 pinctrl support
2014-09-02 16:58 UTC (8+ messages)
` [PATCH v3 1/4] "
` [PATCH v3 2/4] dt: Document Qualcomm APQ8084 pinctrl binding
` [PATCH v3 3/4] ARM: dts: qcom: Add TLMM DT node for APQ8084
` [PATCH v3 4/4] pinctrl: qcom: Make the target processor value configurable
[PATCH v2 0/3] ARM: dts: qcom: Add initial IFC6540 board support
2014-09-02 15:54 UTC (5+ messages)
` [PATCH v2 1/3] ARM: dts: qcom: Add initial IFC6540 board device tree
` [PATCH v2 2/3] ARM: dts: qcom: Enable serial port on IFC6540 boards
` [PATCH v2 3/3] ARM: dts: qcom: Add SDHC nodes for APQ8084 platform
[PATCH] pinctrl: qcom: Release pin ranges when gpiochip_irqchip_add fails
2014-09-02 12:29 UTC (6+ messages)
[PATCH v2] pinctrl: qcom: remove gpiochip in failure cases
2014-09-02 12:28 UTC (5+ messages)
[PATCH V3 00/10] CPUFreq: cpufreq-cpu0 updates for 3.{17|18 ?}
2014-09-01 6:40 UTC (13+ messages)
` [PATCH V3 01/10] cpufreq: Add support for per-policy driver data
` [PATCH V3 02/10] cpufreq: cpu0: Update Module Author
` [PATCH V3 03/10] cpufreq: cpu0: don't validate clock on clk_put()
` [PATCH V3 04/10] cpufreq: cpu0: print relevant error when we defer probe
` [PATCH V3 05/10] cpufreq: cpu0: use dev_{err|warn|dbg} instead of pr_{err|warn|debug}
` [PATCH V3 06/10] cpufreq: cpu0: Move per-cluster initialization code to ->init()
` [PATCH V3 07/10] cpufreq: cpu0: try regulators with name "cpu-supply"
` [PATCH V3 08/10] cpufreq: cpu0: Make allocate_resources() work for any CPU
` [PATCH V3 09/10] cpufreq: cpu0: rename driver and internals to 'cpufreq_generic'
` [PATCH V3 10/10] cpufreq: generic: set platform_{driver|device} '.name' to 'cpufreq-generic'
[PATCH 0/4] Add reset support for apq8064
2014-08-29 13:32 UTC (8+ messages)
` [PATCH 1/4] ARM: DT: APQ8064: Add pinctrl support
` [PATCH 2/4] ARM: DT: APQ8064: Add node for ps_hold function in pinctrl
` [PATCH 3/4] pinctrl: msm: Add ps_hold function in pinctrl-apq8064 binding documentation
` [PATCH 4/4] pinctrl: qcom: Add support for reset for apq8064
[PATCH v2 0/3] pinctrl: qcom: Add APQ8084 pinctrl support
2014-08-29 13:10 UTC (11+ messages)
` [PATCH v2 1/3] "
` [PATCH v2 2/3] dt: Document Qualcomm APQ8084 pinctrl binding
` [PATCH v2 3/3] ARM: dts: qcom: Add TLMM DT node for APQ8084
[PATCH v4 1/1] iommu/arm-smmu: Do not access non-existing S2CR registers
2014-08-28 10:55 UTC (3+ messages)
[PATCH 1/3] cpufreq: cpu0: Release clk and regulator in remove function
2014-08-28 7:00 UTC (7+ messages)
` [PATCH 2/3] cpufreq: cpu0: Removes unnecessary IS_ERR check on clk
` [PATCH 3/3] cpufreq: cpu0: Convert pr_ to dev_ as struct device is available
[PATCH v4 0/8] QCOM 8074 cpuidle driver
2014-08-27 20:35 UTC (13+ messages)
` [PATCH v4 4/8] qcom: spm-devices: Add SPM device manager for the SoC
` [PATCH v4 7/8] qcom: cpuidle: Add cpuidle driver for QCOM cpus
[PATCH v3 0/8] QCOM 8074 cpuidle driver
2014-08-27 20:31 UTC (6+ messages)
` [PATCH v3 1/8] msm: scm: Move scm-boot files to drivers/soc and include/soc
[PATCH 1/2] ARM: DT: APQ8064: Add pinctrl support This patch adds device tree nodes to support pinctrl for apq8064 SOC
2014-08-27 13:39 UTC (3+ messages)
` [PATCH 2/2] pinctrl: qcom: Add support for reset for apq8064
[PATCH 3/4] pinctrl: msm: Add ps_hold function in pinctrl-apq8064 binding documentation
2014-08-27 9:43 UTC (2+ messages)
` [PATCH 4/4] ARM: DT: APQ8064: Add node for ps_hold function in pinctrl
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).