messages from 2014-09-03 13:04:20 to 2014-09-11 14:24:51 UTC [more...]
[PATCH v11 2/9] clk: Move all drivers to use internal API
2014-09-11 14:24 UTC
[PATCH v4 1/2] timer: provide an api for deferrable timeout
2014-09-11 13:25 UTC (15+ messages)
` [PATCH v4 2/2] ksm: provide support to use deferrable timers for scanner thread
[PATCH V3 00/16] UFS: Power management support
2014-09-11 13:09 UTC (21+ messages)
` [PATCH V3 01/16] scsi: support well known logical units
` [PATCH V3 02/16] scsi: balance out autopm get/put calls in scsi_sysfs_add_sdev()
` [PATCH V3 03/16] scsi: ufs: Allow vendor specific initialization
` [PATCH V3 04/16] scsi: ufs: Add regulator enable support
` [PATCH V3 05/16] scsi: ufs: Add clock initialization support
` [PATCH V3 06/16] scsi: ufs: refactor query descriptor API support
` [PATCH V3 07/16] scsi: ufs: improve init sequence
` [PATCH V3 08/16] scsi: ufs: Active Power Mode - configuring bActiveICCLevel
` [PATCH V3 09/16] scsi: ufs: introduce well known logical unit in ufs
` [PATCH V3 10/16] scsi: ufs: add UFS power management support
` [PATCH V3 11/16] scsi: ufs: refactor configuring power mode
` [PATCH V3 12/16] scsi: ufs: Add support for clock gating
` [PATCH V3 13/16] scsi: ufs: Add freq-table-hz property for UFS device
` [PATCH V3 14/16] scsi: ufs: Add support for clock scaling using devfreq framework
` [PATCH V3 15/16] scsi: ufs: tune bkops while power managment events
` [PATCH V3 16/16] scsi: ufs: definitions for phy interface
kexec on APQ8074
2014-09-11 9:47 UTC (2+ messages)
[PATCH v2] arm: perf: Don't sleep while atomic when enabling per-cpu interrupts
2014-09-11 9:39 UTC (2+ messages)
[PATCH v5 0/7] QCOM 8074 cpuidle driver
2014-09-11 6:59 UTC (12+ messages)
` [PATCH v5 1/7] msm: scm: Add SCM warmboot flags for quad core targets
` [PATCH v5 2/7] qcom: spm: Add Subsystem Power Manager driver (SAW2)
` [PATCH v5 3/7] qcom: spm-devices: Add SPM device manager for the SoC
` [PATCH v5 4/7] arm: dts: qcom: Add SPM device bindings for 8974
` [PATCH v5 5/7] qcom: msm-pm: Add cpu low power mode functions
` [PATCH v5 6/7] qcom: cpuidle: Add cpuidle driver for QCOM cpus
` [PATCH v5 7/7] arm: dts: qcom: Add idle states device nodes for 8974
[RESEND PATCH 0/2] Add Qualcomm ADM dmaengine driver
2014-09-11 2:18 UTC (3+ messages)
` [PATCH 1/2] dmaengine: Add QCOM ADM DMA driver
` [PATCH 2/2] dmaengine: qcom_adm: Add device tree binding
[PATCH] ARM: perf: Don't sleep while atomic when enabling per-cpu interrupts
2014-09-10 18:51 UTC (5+ messages)
[PATCH] cpufreq: dt: Support platforms with separate clock lines for each CPU
2014-09-10 18:15 UTC (28+ messages)
` [PATCH 0/4] cpufreq-dt, platform_data based proposal
` [PATCH 1/4] cpufreq: allow driver-specific flags
` [PATCH 2/4] cpufreq: cpufreq-dt: extend with platform_data
` [PATCH 3/4] ARM: mvebu: use the cpufreq-dt platform_data for independent clocks
` [PATCH 4/4] cpufreq: cpufreq-dt: remove warning about regulators
` [PATCHv2 0/4] cpufreq-dt, platform_data based proposal
` [PATCHv2 1/4] cpufreq: allow driver-specific data
` [PATCHv2 2/4] cpufreq: cpufreq-dt: extend with platform_data
` [PATCHv2 3/4] ARM: mvebu: use the cpufreq-dt platform_data for independent clocks
` [PATCHv2 4/4] cpufreq: cpufreq-dt: adjust message related to regulators
Status of chipidea msm USB reset patch
2014-09-10 10:56 UTC (10+ messages)
` Fwd: "
[PATCH v3 0/3] mmc: mmci: sdio related fixes
2014-09-10 10:51 UTC (11+ messages)
` [PATCH v3 1/3] mmc: mmci: Support any block sizes for ux500v2 and qcom variant
` [PATCH v3 2/3] mmc: mmci: Add sdio enable mask in variant data
` [PATCH v3 3/3] mmc: mmci: rename sdio flag in vendor data to st_sdio
` [PATCH] mmc: mmci_qcom_dml: fix is never less than zero warning
[PATCH 0/2] Intial support for voltage ADC
2014-09-10 9:49 UTC (11+ messages)
` [PATCH 1/2] iio: vadc: Qualcomm SPMI PMIC voltage ADC driver
` [PATCH 2/2] DT: iio: vadc: document dt binding
[RFC/PATCH 00/12] Krait clocks + Krait CPUfreq
2014-09-10 1:44 UTC (5+ messages)
` [RFC/PATCH 02/12] clk: Add safe switch hook
[PATCH v4 1/3] ahci-platform: Bump max number of clocks to 5
2014-09-09 15:36 UTC (3+ messages)
` [PATCH v4 2/3] ata: Add Qualcomm ARM SoC AHCI SATA host controller driver
` [PATCH v4 3/3] ata: qcom: Add device tree bindings information
use IORESOURCE_REG resource type for non-translatable addresses in DT
2014-09-09 15:07 UTC (7+ messages)
` [PATCH] RFC: add function for localbus address
[PATCH Resend] cpufreq: cpu0: rename driver and internals to 'cpufreq_dt'
2014-09-09 14:28 UTC
[PATCH v10 2/9] clk: Move all drivers to use internal API
2014-09-09 14:04 UTC
[PATCH V3 00/10] CPUFreq: cpufreq-cpu0 updates for 3.{17|18 ?}
2014-09-09 13:52 UTC (11+ messages)
` [PATCH V3 09/10] cpufreq: cpu0: rename driver and internals to 'cpufreq_generic'
[PATCH v4 1/3] ahci-platform: Bump max number of clocks to 5
2014-09-09 7:58 UTC (5+ messages)
` [PATCH v4 2/3] ata: Add Qualcomm ARM SoC AHCI SATA host controller driver
` [PATCH v4 3/3] ata: qcom: Add device tree bindings information
[PATCH v2 00/15] Krait clocks + Krait CPUfreq
2014-09-09 4:53 UTC (24+ messages)
` [PATCH v2 01/15] clk: mux: Add unregistration API
` [PATCH v2 02/15] clk: mux: Split out register accessors for reuse
` [PATCH v2 03/15] clk: Add __clk_mux_determine_rate_closest
` [PATCH v2 04/15] clk: divider: Make generic for usage elsewhere
` [PATCH v2 05/15] clk: Add safe switch hook
` [PATCH v2 06/15] clk: Avoid sending high rates to downstream clocks during set_rate
` [PATCH v2 07/15] clk: qcom: Add support for High-Frequency PLLs (HFPLLs)
` [PATCH v2 08/15] clk: qcom: Add HFPLL driver
` [PATCH v2 09/15] clk: qcom: Add MSM8960/APQ8064's HFPLLs
` [PATCH v2 10/15] clk: qcom: Add IPQ806X's HFPLLs
` [PATCH v2 11/15] clk: qcom: Add support for Krait clocks
` [PATCH v2 12/15] clk: qcom: Add KPSS ACC/GCC driver
` [PATCH v2 13/15] clk: qcom: Add Krait clock controller driver
` [PATCH v2 14/15] cpufreq: Add module to register cpufreq on Krait CPUs
` [PATCH v2 15/15] ARM: dts: qcom: Add necessary DT data for Krait cpufreq
[PATCH v3] hwspinlock: qcom: Add support for Qualcomm HW Mutex block
2014-09-08 17:57 UTC (6+ messages)
[PATCH] dmaengine: qcom_bam_dma: add one more optional clock
2014-09-08 15:43 UTC (3+ messages)
[PATCH v9 2/6] clk: Move all drivers to use internal API
2014-09-08 6:13 UTC (2+ messages)
[PATCH] ARM: debug: Update MSM and QCOM DEBUG_LL help
2014-09-05 22:51 UTC
[PATCH v3] ARM: dts: qcom: Add initial IFC6540 board device tree
2014-09-05 16:00 UTC (5+ messages)
[PATCH] ARM: msm: Update the references to DEBUG_MSM_UARTx
2014-09-05 7:23 UTC (5+ messages)
` [PATCH v2] "
[PATCH v4 0/4] pinctrl: qcom: Add APQ8084 pinctrl support
2014-09-05 7:20 UTC (10+ messages)
` [PATCH v4 1/4] "
` [PATCH v4 2/4] dt: Document Qualcomm APQ8084 pinctrl binding
` [PATCH v4 3/4] ARM: dts: qcom: Add TLMM DT node for APQ8084
` [PATCH v4 4/4] pinctrl: qcom: Make the target processor value configurable
[PATCH] genirq: Introduce irq_read_line()
2014-09-05 0:14 UTC (2+ messages)
[PATCH] mmc: sdhci-msm: Make tuning block table endian agnostic
2014-09-04 22:01 UTC (6+ messages)
[PATCH] clk: qcom: Consolidate frequency finding logic
2014-09-04 21:11 UTC
[PATCH v2 0/4] Use wound/wait mutexes in the common clock framework
2014-09-04 1:01 UTC (5+ messages)
` [PATCH v2 1/4] clk: Recalc rate and accuracy in underscore functions if not caching
` [PATCH v2 2/4] clk: Make __clk_lookup() use a list instead of tree search
` [PATCH v2 3/4] clk: Use lockless functions for debug printing
` [PATCH v2 4/4] clk: Use ww_mutexes for clk_prepare_{lock/unlock}
FROM: Husam Al Sayed
2014-09-03 18:24 UTC
[PATCH] mmc: sdhci-msm: Make tuning block table endian agnostic
2014-09-03 13:37 UTC (3+ messages)
[PATCH/RFC V2 00/16] UFS: Power managment support
2014-09-03 13:04 UTC (5+ messages)
` [PATCH/RFC V2 10/16] scsi: ufs: add UFS power management support
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox