messages from 2016-05-16 10:41:03 to 2016-06-02 19:15:32 UTC [more...]
[PATCH 0/5] Patches for QCOM IPQ4019 clock driver
2016-06-02 19:15 UTC (10+ messages)
` [PATCH 1/5] clk: qcom: ipq4019: Modified the fixed clock rate to proper values
` [PATCH 2/5] clk: qcom: ipq4019: Added the apss cpu pll divider clock node
` [PATCH 3/5] clk: qcom: ipq4019: Added the cpu pll divider and changed regmap limit
` [PATCH 4/5] clk: qcom: ipq4019: Added the cpu clock frequency change notifier
` [PATCH 5/5] clk: qcom: ipq4019: Added the turbo frequency for apps cpu
[PATCH] tty: serial: msm: Disable restoring Rx interrupts for DMA Mode
2016-06-02 18:37 UTC (7+ messages)
What is the Surf board , really?
2016-06-02 18:04 UTC (3+ messages)
[RFC PATCH v1 0/3] regulator: qcom_smd: add list_voltage callback support
2016-06-02 16:24 UTC (11+ messages)
` [RFC PATCH v1 1/3] regulator: helpers: consider constriants in list_voltage_linear_range
` [RFC PATCH v1 2/3] regulator: qcom_smd: add list_voltage callback
` [RFC PATCH v1 3/3] regulator: qcom_smd: add linear range to pm8941 lnldo
[PATCH 00/20] drm/atomic: Provide default ->best_encoder() behavior
2016-06-02 14:31 UTC (21+ messages)
` [PATCH 01/20] drm/atomic: Fix remaining places where !funcs->best_encoder is valid
` [PATCH 02/20] drm: arc: Rely on the default ->best_encoder() behavior
` [PATCH 03/20] drm: atmel-hlcdc: "
` [PATCH 04/20] drm: exynos: "
` [PATCH 05/20] drm: fsl-dcu: "
` [PATCH 06/20] drm: i915: Rely on the default ->best_encoder() behavior where appropriate
` [PATCH 07/20] drm: mediatek: Rely on the default ->best_encoder() behavior
` [PATCH 08/20] drm: msm: Rely on the default ->best_encoder() behavior where appropriate
` [PATCH 09/20] drm: rcar-du: Rely on the default ->best_encoder() behavior
` [PATCH 10/20] drm: rockchip: "
` [PATCH 11/20] drm: sti: "
` [PATCH 12/20] drm: sun4i: "
` [PATCH 13/20] drm: tegra: "
` [PATCH 14/20] drm: vc4: "
` [PATCH 15/20] drm: virtgpu: "
` [PATCH 16/20] drm: omap: "
` [PATCH 17/20] drm/bridge: anx78xx: "
` [PATCH 18/20] drm/bridge: ptn3460: "
` [PATCH 19/20] drm/bridge: ps8622: "
` [PATCH 20/20] drm/bridge: dw-hdmi: Use drm_atomic_helper_best_encoder()
Fw:Re: [RFC PATCH 0/4] Command Queueing Support in eMMC
2016-06-02 2:23 UTC (2+ messages)
[PATCH 1/2] [v4] net: emac: emac gigabit ethernet controller driver
2016-06-01 22:27 UTC (3+ messages)
[PATCH] ARM: defconfig: enable the MSM8660 pin controller
2016-06-01 22:05 UTC (2+ messages)
[RFT PATCH 1/2] serial: Fix console setup section mismatch
2016-05-31 14:34 UTC (4+ messages)
` [RFT PATCH 2/2] serial: pnx8xxx: Fix coding style
[RFC v2 0/3] ASoC: Add support to Qualcomm msm8916-wcd codec
2016-05-31 8:52 UTC (9+ messages)
` [RFC v2 1/3] ASoC: msm8916: Add codec Device Tree bindings
` [RFC v2 2/3] ASoC: Introduce SOC_SINGLE_S8_TLV() macro
` Applied "ASoC: Introduce SOC_SINGLE_S8_TLV() macro" to the asoc tree
` [RFC v2 3/3] ASoC: msm8916: Add msm8916-wcd codec driver
Hello
2016-05-29 0:44 UTC
[PATCH V6 0/8] vfio, platform: add ACPI support
2016-05-28 22:01 UTC (9+ messages)
` [PATCH V6 1/8] vfio: platform: move reset call to a common function
` [PATCH V6 2/8] vfio: platform: determine reset capability
` [PATCH V6 3/8] vfio: platform: add support for ACPI probe
` [PATCH V6 4/8] vfio: platform: add extra debug info argument to call reset
` [PATCH V6 5/8] vfio: platform: call _RST method when using ACPI
` [PATCH V6 6/8] vfio, platform: make reset driver a requirement by default
` [PATCH V6 7/8] vfio: platform: check reset call return code during open
` [PATCH V6 8/8] vfio: platform: check reset call return code during release
[PATCH v2 1/2] dt: binding: Add Qualcomm WCNSS control binding
2016-05-27 4:28 UTC (3+ messages)
[PATCH V3 0/2] i2c: qup: Some misc fixes
2016-05-26 22:01 UTC (5+ messages)
` [PATCH V3 1/2] i2c: qup: Fix broken dma when CONFIG_DEBUG_SG is enabled
` [PATCH V3 2/2] i2c: qup: Fix error handling
[PATCH] soc: qcom: provide mechanism for drivers to access L2 registers
2016-05-26 20:38 UTC (13+ messages)
[PATCH 1/2][v3] i2c: qup: add ACPI support
2016-05-26 19:37 UTC (2+ messages)
` [PATCH 2/2][v4] i2c: qup: support SMBus block read
[PATCH v3 1/2] i2c: qup: add ACPI support
2016-05-26 15:42 UTC (6+ messages)
` [PATCH v3 2/2] i2c: qup: support SMBus block read
[PATCH] usb: host: ehci-msm: Conditionally call ehci suspend/resume
2016-05-26 6:58 UTC (3+ messages)
[PATCH] tty: serial: msm: Remove duplicate handling of clocks
2016-05-25 23:07 UTC (3+ messages)
[Patch v5 0/8] Qualcomm SCM Rework
2016-05-25 21:15 UTC (9+ messages)
` [Patch v5 1/8] dt/bindings: firmware: Add Qualcomm SCM binding
` [Patch v5 5/8] firmware: qcom: scm: Convert to streaming DMA APIS
[PATCH v2 0/9] Qualcomm WCNSS remoteproc
2016-05-25 19:00 UTC (4+ messages)
` [PATCH v2 4/9] remoteproc: Introduce Qualcomm WCNSS firmware loader
[PATCH V5 0/7] iommu/msm: Add DT adaptation and generic bindings support
2016-05-25 16:49 UTC (20+ messages)
` [PATCH V5 1/7] iommu/msm: Add DT adaptation
` [PATCH V5 2/7] documentation: iommu: Add bindings for msm,iommu-v0 ip
` [PATCH V5 3/7] iommu/msm: Move the contents from msm_iommu_dev.c to msm_iommu.c
` [PATCH V5 4/7] iommu/msm: Add support for generic master bindings
` [PATCH V5 5/7] iommu/msm: use generic ARMV7S short descriptor pagetable ops
` [PATCH V5 6/7] iommu/msm: Use writel_relaxed and add a barrier
` [PATCH V5 7/7] iommu/msm: Remove driver BROKEN
[PATCH v3] qcom: ipq4019: add wifi nodes to ipq4019 SoC device tree
2016-05-25 14:10 UTC
[PATCH v2 0/5] drm/i2c: adv7511: ADV7533 support
2016-05-24 5:15 UTC (7+ messages)
` [PATCH v3 7/7] dt-bindings: drm/bridge: Update bindings for ADV7533
[PATCH V5 0/6] vfio, platform: add ACPI support
2016-05-24 2:25 UTC (18+ messages)
` [PATCH V5 1/6] vfio: platform: rename reset function
` [PATCH V5 2/6] vfio: platform: move reset call to a common function
` [PATCH V5 3/6] vfio: platform: determine reset capability
` [PATCH V5 4/6] vfio: platform: add support for ACPI probe
` [PATCH V5 5/6] vfio: platform: call _RST method when using ACPI
` [PATCH V5 6/6] vfio, platform: make reset driver a requirement by default
[PATCH v2 1/2] i2c: qup: add ACPI support
2016-05-23 17:45 UTC (10+ messages)
` [PATCH v2 2/2] i2c: qup: support SMBus block read
[PATCH 04/54] MAINTAINERS: Add file patterns for qcom device tree bindings
2016-05-22 9:05 UTC
[RFC 0/8] usb: phy: msm: various cleanups
2016-05-20 14:15 UTC (14+ messages)
` [RFC 1/8] usb: phy: move msm_hsusb.h into driver
` [RFC 2/8] usb: ehci-msm: call usb_phy_init instead of open-coding it
` [RFC 3/8] usb: chipidea: msm: remove open-coded phy init
` [RFC 4/8] usb: phy: move TCSR driver into new file
` [RFC 5/8] usb: phy: msm: move register definitions into driver
` [RFC 6/8] usb: phy: qcom: use bulk regulator interfaces
` [RFC 7/8] usb: phy: msm: remove v1p8/v3p3 voltage setting
` [RFC 8/8] usb: phy: msm: disable regulator for remove()
[PATCH V4 0/7] iommu/msm: Add DT adaptation and generic bindings support
2016-05-20 11:18 UTC (10+ messages)
` [PATCH V4 2/7] documentation: iommu: Add bindings for msm,iommu-v0 ip
` [PATCH V4 6/7] iommu/msm: Use writel_relaxed and add a barrier
[PATCH 0/5] Qualcomm Suspend to Idle Support
2016-05-20 6:09 UTC (9+ messages)
` [PATCH 1/5] soc: qcom: Add suspend to idle support
` [PATCH 2/5] arm: defconfig: Enable PM8941 pwr key
` [PATCH 3/5] arm64: dts: msm8916: Add spc compat tag
` [PATCH 4/5] ARM: dts: qcom: Remove size elements from pmic reg
` [PATCH 5/5] ARM: dts: qcom: pma8084: Add pwrkey entry
[PATCH 1/1] drm/msm/mdp4: avoid possible null pointer dereference
2016-05-18 21:06 UTC
[PATCH v3 0/7] drm/i2c: adv7511: ADV7533 support
2016-05-16 10:41 UTC (9+ messages)
` [PATCH v4 "
` [PATCH v4 1/7] drm/i2c: adv7511: Convert to drm_bridge
` [PATCH v4 2/7] drm/i2c: adv7511: Fix mutex deadlock when interrupts are disabled
` [PATCH v4 3/7] drm/i2c: adv7511: Initial support for ADV7533
` [PATCH v4 4/7] drm/i2c: adv7533: Create a MIPI DSI device
` [PATCH v4 5/7] drm/i2c: adv7533: Use internal timing generator
` [PATCH v4 6/7] drm/i2c: adv7533: Change number of DSI lanes dynamically
` [PATCH v4 7/7] dt-bindings: drm/bridge: Update bindings for ADV7533
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).