Re: [PATCH RFC 4/8] media: qcom: camss: Prepare CSID for C-PHY support

[Bryan O'Donoghue <bryan.odonoghue@linaro.org>]

On 09/11/2025 09:39, David Heidelberg via B4 Relay wrote:
> From: David Heidelberg <david@ixit.cz>
> 
> Inherit C-PHY information from CSIPHY, so we can configure CSID
> properly.
> 
> CSI2_RX_CFG0_PHY_TYPE_SEL must be set to 1, when C-PHY mode is used.
> 
> Signed-off-by: David Heidelberg <david@ixit.cz>
> ---
>   drivers/media/platform/qcom/camss/camss-csid-gen2.c | 1 +
>   drivers/media/platform/qcom/camss/camss-csid.c      | 1 +
>   drivers/media/platform/qcom/camss/camss-csid.h      | 1 +
>   3 files changed, 3 insertions(+)
> 
> diff --git a/drivers/media/platform/qcom/camss/camss-csid-gen2.c b/drivers/media/platform/qcom/camss/camss-csid-gen2.c
> index 2a1746dcc1c5b..033036ae28a4f 100644
> --- a/drivers/media/platform/qcom/camss/camss-csid-gen2.c
> +++ b/drivers/media/platform/qcom/camss/camss-csid-gen2.c
> @@ -183,6 +183,7 @@ static void __csid_configure_rx(struct csid_device *csid,
>   	val = (lane_cnt - 1) << CSI2_RX_CFG0_NUM_ACTIVE_LANES;
>   	val |= phy->lane_assign << CSI2_RX_CFG0_DL0_INPUT_SEL;
>   	val |= phy->csiphy_id << CSI2_RX_CFG0_PHY_NUM_SEL;
> +	val |= csid->phy.cphy << CSI2_RX_CFG0_PHY_TYPE_SEL;
>   	writel_relaxed(val, csid->base + CSID_CSI2_RX_CFG0);
>   
>   	val = 1 << CSI2_RX_CFG1_PACKET_ECC_CORRECTION_EN;
> diff --git a/drivers/media/platform/qcom/camss/camss-csid.c b/drivers/media/platform/qcom/camss/camss-csid.c
> index 5284b5857368c..68adea33cc719 100644
> --- a/drivers/media/platform/qcom/camss/camss-csid.c
> +++ b/drivers/media/platform/qcom/camss/camss-csid.c
> @@ -1287,6 +1287,7 @@ static int csid_link_setup(struct media_entity *entity,
>   		csid->phy.csiphy_id = csiphy->id;
>   
>   		lane_cfg = &csiphy->cfg.csi2->lane_cfg;
> +		csid->phy.cphy = lane_cfg->cphy;
>   		csid->phy.lane_cnt = lane_cfg->num_data;
>   		csid->phy.lane_assign = csid_get_lane_assign(lane_cfg);
>   	}
> diff --git a/drivers/media/platform/qcom/camss/camss-csid.h b/drivers/media/platform/qcom/camss/camss-csid.h
> index aedc96ed84b2f..a82db31bd2335 100644
> --- a/drivers/media/platform/qcom/camss/camss-csid.h
> +++ b/drivers/media/platform/qcom/camss/camss-csid.h
> @@ -70,6 +70,7 @@ struct csid_phy_config {
>   	u32 lane_assign;
>   	u32 en_vc;
>   	u8 need_vc_update;
> +	bool cphy;
>   };
>   
>   struct csid_device;
> 

I'm not convinced you need another flag for this. It should be possible 
for the CSID to get a pointer to the PHY and interrogate the encoded mode.

---
bod