Linux-Aspeed Archive on lore.kernel.org
 help / color / mirror / Atom feed
 messages from 2026-09-02 21:02:17 to 2026-09-11 12:53:42 UTC [more...]

[PATCH v3 0/8] drm: replace simple display pipe users with atomic helpers
 2026-09-11 12:53 UTC  (3+ messages)
` [PATCH v3 5/8] drm/gm12u320: replace struct drm_simple_display_pipe with regular "

[PATCH v3 0/3] Add AST2700 USB3.2 PHY driver
 2026-09-10  7:12 UTC  (8+ messages)
` [PATCH v3 1/3] dt-bindings: phy: aspeed: Document AST2700 USB3.2 PHY
` [PATCH v3 2/3] phy: aspeed: Add AST2700 USB3.2 PHY driver
` [PATCH v3 3/3] MAINTAINERS: Add ASPEED USB3 "

[PATCH] ARM: dts: aspeed: anacapa: add NCT7363 fan controllers
 2026-09-09  8:25 UTC 

[PATCH v2 0/8] Add Aspeed AST2700 SDRAM EDAC support
 2026-09-09  5:59 UTC  (5+ messages)

[PATCH 0/8] i3c: mipi-i3c-hci: Add Aspeed AST2700 support
 2026-09-09  5:38 UTC  (18+ messages)
` [PATCH 1/8] dt-bindings: i3c: Document the AST2700 I3C controller
    ` 回覆: "
` [PATCH 2/8] i3c: mipi-i3c-hci: Support address-indexed DAT slots
    ` 回覆: "
` [PATCH 3/8] i3c: mipi-i3c-hci: Add a quirk for 64-bit DMA addressing
    ` 回覆: "
` [PATCH 4/8] i3c: mipi-i3c-hci: Add a quirk to clear the TX start threshold
    ` 回覆: "
` [PATCH 5/8] i3c: mipi-i3c-hci: Add support for the AST2700 I3C controller
    ` 回覆: "

[PATCH v2 0/4] Add support for StarFive JHB100 UART Routing
 2026-09-07  1:24 UTC  (8+ messages)
` [PATCH v2 1/4] uart-routing: Add common UART routing framework
` [PATCH v2 3/4] dt-bindings: uart-routing: Add binding for StarFive JHB100 UART routing
` [PATCH v2 4/4] uart-routing: Add UART Routing driver for StarFive JHB100 SoC

[PATCH v2] ARM: dts: aspeed: msx4: describe the I2C5 mux tree
 2026-09-04  9:34 UTC 

[PATCH] ARM: dts: aspeed: msx4: describe the I2C5 mux tree
 2026-09-03 10:59 UTC 

[PATCH v2 0/6] media: Use devm_of_reserved_mem_device_init()
 2026-09-03  3:08 UTC  (8+ messages)
` [PATCH v2 1/6] media: synopsys: hdmirx: "
` [PATCH v2 2/6] media: aspeed: "
` [PATCH v2 3/6] media: nuvoton: npcm-video: "
` [PATCH v2 4/6] media: arm: mali-c55: "
` [PATCH v2 5/6] media: mediatek: vpu: "
` [PATCH v2 6/6] staging: media: cedrus: "

[PATCH v8 00/11] ARM: dts: aspeed: anacapa: restructure devicetree for development-phase
 2026-09-02 10:21 UTC  (12+ messages)
` [PATCH v8 01/11] ARM: dts: aspeed: anacapa: Add EVT1 devicetree and point wrapper to it
` [PATCH v8 02/11] ARM: dts: aspeed: anacapa: Add EVT2 devicetree inheriting EVT1
` [PATCH v8 03/11] ARM: dts: aspeed: anacapa: Add DVT devicetree inheriting EVT2
` [PATCH v8 04/11] ARM: dts: aspeed: anacapa: Add additional EEPROM node for SCM
` [PATCH v8 05/11] ARM: dts: aspeed: anacapa: Add eeprom device node for NFC adaptor board
` [PATCH v8 06/11] ARM: dts: aspeed: anacapa: Align PDB fan GPIO numbering
` [PATCH v8 07/11] ARM: dts: aspeed: anacapa: Enable MCTP and FRU for NIC
` [PATCH v8 08/11] ARM: dts: aspeed: anacapa: evt2: Add shunt resistor values for HSC monitors
` [PATCH v8 09/11] ARM: dts: aspeed: anacapa: Add LPDB fuse monitor GPIO expander
` [PATCH v8 10/11] ARM: dts: aspeed: anacapa: Simplify leakage GPIO line names
` [PATCH v8 11/11] ARM: dts: aspeed: anacapa: Add SPI flash VCC supply

[PATCH v2 0/11] drm: Use devm_of_reserved_mem_device_init()
 2026-09-02 20:55 UTC  (13+ messages)
` [PATCH v2 1/11] drm: logicvc: "
` [PATCH v2 2/11] drm: hdlcd: "
` [PATCH v2 3/11] drm: pl111: "
` [PATCH v2 4/11] drm: komeda: "
` [PATCH v2 5/11] drm: malidp: "
` [PATCH v2 6/11] drm: ingenic: "
` [PATCH v2 7/11] drm: kmb: "
` [PATCH v2 8/11] drm: sun4i: "
` [PATCH v2 9/11] drm: xlnx: zynqmp_dpsub: "
` [PATCH v2 10/11] drm: aspeed: "
` [PATCH v2 11/11] drm: arcpgu: "

[PATCH 00/45] clk: Make sure clk_init_data is fully initialized (part two)
 2026-09-02  7:18 UTC  (3+ messages)
` [PATCH 30/45] clk: scpi: Make sure clk_init_data is fully initialized

[PATCH] peci: aspeed: Initialize state before requesting IRQ
 2026-09-02 14:26 UTC 


This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox