[PATCH v2 0/2] Add definition for GPIO direction

[Linus Walleij <linus.walleij@linaro.org>]

On Wed, Nov 6, 2019 at 1:25 PM Vaittinen, Matti
<Matti.Vaittinen@fi.rohmeurope.com> wrote:
> On Wed, 2019-11-06 at 13:08 +0100, Sebastian Reichel wrote:
> > On Wed, Nov 06, 2019 at 10:51:06AM +0200, Matti Vaittinen wrote:
> > > The patch series adds definitions for GPIO line directions.
> > >
> > > For occasional GPIO contributor like me it is always a pain to
> > > remember
> > > whether 1 or 0 was used for GPIO direction INPUT/OUTPUT.
> >
> > Maybe also update the GPIO drivers in pinctrl?
(...)
> Ouch. I didn't check from pinctrl but I see those should be converted
> as well. I'm a bit short on time right now so if anyone else is
> interested I won't mind :)
>
> Luckily the value for IN and OUT is not changed - only the defines were
> added - so all of the drivers do not need to be done at once. If no one
> else will take the pinctrl part then I can probably do pinctrl patches
> for v5.6 cycle.

No hurry with that. This is a good start, we don't have to fix
the whole world at once.

Let's look at this for v5.6.

Yours,
Linus Walleij