Dear,

I could use those step to connect the Linux SP to Windows Series profile

At the linux side:
step 1:rfcomm connect 0 <BD address> 1

setp 2:open minicom -s,

set the device as /dev/rfcomm0

set the baud rate as 19200 8N1, no flow control

exit

At the windows site:

step 1: open the hyerpterminal,

set up baud rate as 19200 8N1 , no flow control

step 2: sucessfuly transfer the data

But I hope ass the SP profile service record into SDP daemon, I do thoe step

At the linux side

step 1: rfcomm bind 0 <BD Addreess> 1

step 2: sdp add SP 1

At the windows site:

step1: Obrowse the SP service

step 2: reject SP connect, the port is not correct.

Taylor Shieh
Engineer, Bluetooth Module Section
New Technology Development Dept., R&D Division
Tel:886-49-2325876 Ext:2188