Hi Folks,

I got the problematic i-Tec dongle working. The important thing is to
send a HCI_Reset as the first command at initialization. We don't do
this, but I can't remember why not. Maybe there were some problematic
chips in the early times of BlueZ. The attached patch is against 2.6.

And here is the new dongle:

hci0:   Type: USB
        BD Address: 00:03:C9:xx:xx:xx ACL MTU: 377:10  SCO MTU: 16:0
        UP RUNNING PSCAN ISCAN 
        RX bytes:107 acl:0 sco:0 events:14 errors:0
        TX bytes:303 acl:0 sco:0 commands:14 errors:0
        Features: 0xff 0xff 0x0d 0x38 0x08 0x08 0x00 0x00
                <3-slot packets> <5-slot packets> <encryption> <slot offset> 
                <timing accuracy> <role switch> <hold mode> <sniff mode> 
                <park state> <RSSI> <channel quality> <SCO link> 
                <HV2 packets> <HV3 packets> <u-law log> <A-law log> 
                <CVSD> <power control> <transparent SCO> <enhanced iscan> 
                <interlaced iscan> <interlaced pscan> <AFH cap. slave> <AFH cap. master> 
        Packet type: DM1 DM3 DM5 DH1 DH3 DH5 HV1 HV2 HV3 
        Link policy: RSWITCH HOLD SNIFF PARK 
        Link mode: SLAVE ACCEPT 
        Name: 'Broadcom BCM2035'
        Class: 0x000100
        Service Classes: Unspecified
        Device Class: Computer, Uncategorized
        HCI Ver: 1.1 (0x1) HCI Rev: 0x69 LMP Ver: 1.1 (0x1) LMP Subver: 0xe00
        Manufacturer: Broadcom Corporation (15)

The nice thing is that it already supports AFH ;)

Regards

Marcel