Hi,


> add 
> 
> none            /proc/bus/usb   usbdevfs faults                 0       0
> 
> into /etc/fstab
> 
> then write
> mount -a 

It's done.
After a reboot, I did  "mount -t usbdevfs none /proc/bus/usb" from the
USB-howto . It confirmed me it was already mounted. But it is strange
that /proc/bus/usb/device file is still empty.

Then I did "hciconfig hci0 up"
and I still have "Can't init device hci0. Connection timed out(110)"

But the hciconfig message changed. It is now: 

"hci0:   Type: USB
        BD Address: 00:00:00:00:00:00 ACL MTU: 0:0  SCO MTU: 0:0
        DOWN
        RX bytes:0 acl:0 sco:0 events:0 errors:0
        TX bytes:6 acl:0 sco:0 commands:2 errors:0"

No idea why I have so much difficulties with this dongle.

Regards,

Ben