[Bluez-devel] Re: CSR firmware question...

[Marcel Holtmann <marcel@holtmann.org>]

Hi Jean,

> > try running hid2hci :)
> 
> 	Try, and it won't work, the device doesn't even have a control
> pipe anymore. Dead.

as far as I know, every USB device has a control endpoint.

> > If this does not work, show us /proc/bus/usb/devices.
> 
> T:  Bus=01 Lev=01 Prnt=01 Port=01 Cnt=02 Dev#=  5 Spd=12  MxCh= 0
> D:  Ver= 1.10 Cls=00(>ifc ) Sub=00 Prot=00 MxPS= 8 #Cfgs=  1
> P:  Vendor=0a12 ProdID=1000 Rev=12.41
> C:* #Ifs= 2 Cfg#= 1 Atr=e0 MxPwr=  0mA
> I:  If#= 0 Alt= 0 #EPs= 1 Cls=03(HID  ) Sub=01 Prot=01 Driver=(none)
> E:  Ad=81(I) Atr=03(Int.) MxPS=  16 Ivl=1ms
> I:  If#= 1 Alt= 0 #EPs= 1 Cls=03(HID  ) Sub=01 Prot=02 Driver=(none)
> E:  Ad=82(I) Atr=03(Int.) MxPS=  16 Ivl=1ms
> 
> 	(That's with 2.4.X. Under 2.6.X, I can't make sense of the usb stuff).

your firmware update must be successful, because this looks like a
dongle with HCI 18.1 firmware in HID mode. Use hid2hci. It must work.

Regards

Marcel




-------------------------------------------------------
SF.Net email is sponsored by Shop4tech.com-Lowest price on Blank Media
100pk Sonic DVD-R 4x for only $29 -100pk Sonic DVD+R for only $33
Save 50% off Retail on Ink & Toner - Free Shipping and Free Gift.
http://www.shop4tech.com/z/Inkjet_Cartridges/9_108_r285
_______________________________________________
Bluez-devel mailing list
Bluez-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bluez-devel