[Bluez-users] Re: Toshiba and BT (SuSE 9.2)

Marcel Holtmann
2004-12-13T20:03:47Z

Hi Peter,

> here I'm again, the story is still runing. Now I'm able to connect to
> the BT-accesspoint with pand only a short time till timeout.
> I tried hcitool cc <baddr>
> At first I have to start dmabt
>
> Linux-Notebook:~ # dmabt
>
> then
>
> Linux-Notebook:~ # hcitool scan
>
> Scanning ...
>
> 00:0B:CE:00:01:8F Bluetooth-Modul
>
> the next step was
>
> Linux-Notebook:~ # hcitool cc 00:0B:CE:00:01:8F
>
> Linux-Notebook:~ # hcitool con
>
> Connections:
>
> < ACL 00:0B:CE:00:01:8F handle 41 state 1 lm SLAVE
>
> Linux-Notebook:~ # ip link show
>
> 1: lo: <LOOPBACK,UP> mtu 16436 qdisc noqueue
>
> link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
>
> 2: eth0: <BROADCAST,MULTICAST,NOTRAILERS,UP> mtu 1500 qdisc pfifo_fast
> qlen 1000
>
> link/ether 00:08:0d:a9:18:53 brd ff:ff:ff:ff:ff:ff
>
> 3: sit0: <NOARP> mtu 1480 qdisc noqueue
>
> link/sit 0.0.0.0 brd 0.0.0.0
>
> Linux-Notebook:~ #
>
>
>
> With YaST pand was set as pand --search --master
> and as networkdevice bnep0 was initialized, so I don't understand why
> it doesn't apear within the listing of ip link show.
> The setup of network accesses by YaST for DSL also doesn't give me the
> opportunity to use bnep0 as connection for DSL. There is only as
> PPP-Modus PPP via Ethernet, etc. available, but not PPP via Bluetooth
> as I expected.
>
> Please, what is to do in order to get this foolish bnep0 device
> availabe for DSL? bnep0 only appears in the initialization-area for
> network devices.

maybe it is not a good idea to configure bnep0 with YaST at the moment
and actually I never tried this. If your AP is configured in router mode
then you should simply run "pand -n -c <bdadd>" and then "dhcpcd bnep0".

Regards

Marcel