Luiz, You are completely right. I followed your instructions and my Broadcom Bluetonium (bcm203x module) based chip is working. I hope I did not gloss over any section of information although I am almost positive that I did not. Anyways, any one having this problem has to simply download bluez-firmware and copy the broadcom files onto /usr/lib/hotplug/firmware. Thank you so much. Luiz Fernando Capitulino wrote: Hello Gonzalo, gonzalo briceno wrote: > I installed bluez-firmware-1.0 and bluez-utils-2.9, > however, the problem is not fixed. When I look at > /proc/bus/usb/devices the bluetonium chip is listed > but sure enough, it does not load the usb_hci module. > > Any help? We had the some problem here (but the device is different). On our setup, we copied the firmware files to: /usr/lib/hotplug/firmware/ and reloaded the kernel module. I'm not certain if it is the right thing to do, but it worked. Hope it helps, -- Luiz Fernando N. Capitulino -- Gonzalo Briceno gonzalohbriceno@yahoo.com 267.679.1289 --------------------------------- Do you Yahoo!? Read only the mail you want - Yahoo! Mail SpamGuard.