# Example-file for creating a ppp connection with bluetooth between e.g. a PDA
# and the computer. Move this to /etc/ppp/peers/dun and adapt the following
# options to your needs. The values and options below there are far from
# perfect, but were good in a lot of testcases. They may not be good for you!
#
# Most of the comments were taken from the pppd-manpage for your convenience.
# See there for more information and options

## Enables connection debugging facilities. You should use this if you have problems
#debug

# Baudrate
57600

## Disables the default behaviour when no local IP address is specified,
## which is to determine (if possible) the local IP address from the hostname.
## With this option, the peer will have to supply the local IP address
## during IPCP negotiation (unless it specified explicitly on the command line
## or in an options file).
noipdefault

## Add an entry to this system's ARP [Address Resolution Protocol] table with
## the IP address of the peer and the Ethernet address of this system. This
## will have the effect of making the peer appear to other systems to be on the
## local ethernet.
proxyarp

# IP address of PC : IP address to be assigned to PDA
192.168.1.1:192.168.1.2

# Your DNS server
ms-dns 10.0.0.1

## Enables pppd to alter kernel settings as appropriate. Under Linux, pppd will
## enable IP forwarding (i.e.  set /proc/sys/net/ipv4/ip_forward to 1) if the
## proxyarp option is used, and will enable the dynamic IP address option (i.e.
## set /proc/sys/net/ipv4/ip_dynaddr to 1) in demand mode if the local address
## changes.
ktune

## Do not require the peer to authenticate itself. This option is privileged.
noauth

## Don't use the modem control lines.  With this option, pppd will ignore the
## state of the CD (Carrier Detect) signal from the modem and will not change
## the state of the DTR (Data Terminal Ready) signal.
local

## Disable the defaultroute option.
nodefaultroute

## Disable the IPXCP and IPX protocols. 
noipx