[PATCH v1 1/4] Bluetooth: hci_intel: enable on new platform

[Andy Shevchenko <andriy.shevchenko@linux.intel.com>]

On new Intel platform the device is provided with INT33E3 ID.
Append it to the list.

This will require ACPI_GPIO_QUIRK_ONLY_GPIOIO to be enabled because
the relevant ASL looks like:

	UartSerialBusV2 ( ... )
	GpioInt ( ... ) { ... }
	GpioIo ( ... ) { ... }

which means that first GPIO resource is an interrupt, while we are expecting it
to be reset one (output). Do the same for host-wake because in case of
GpioInt() the platform_get_irq() will do the job and should return correct
Linux IRQ number. That said, host-wake GPIO can only be GpioIo() resource.

While here, drop commas in terminator lines.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
---
 drivers/bluetooth/hci_intel.c | 9 +++++----
 1 file changed, 5 insertions(+), 4 deletions(-)

diff --git a/drivers/bluetooth/hci_intel.c b/drivers/bluetooth/hci_intel.c
index f1299da6eed8..703d774be5a6 100644
--- a/drivers/bluetooth/hci_intel.c
+++ b/drivers/bluetooth/hci_intel.c
@@ -1076,7 +1076,8 @@ static const struct hci_uart_proto intel_proto = {
 #ifdef CONFIG_ACPI
 static const struct acpi_device_id intel_acpi_match[] = {
 	{ "INT33E1", 0 },
-	{ },
+	{ "INT33E3", 0 },
+	{ }
 };
 MODULE_DEVICE_TABLE(acpi, intel_acpi_match);
 #endif
@@ -1138,9 +1139,9 @@ static const struct acpi_gpio_params reset_gpios = { 0, 0, false };
 static const struct acpi_gpio_params host_wake_gpios = { 1, 0, false };
 
 static const struct acpi_gpio_mapping acpi_hci_intel_gpios[] = {
-	{ "reset-gpios", &reset_gpios, 1 },
-	{ "host-wake-gpios", &host_wake_gpios, 1 },
-	{ },
+	{ "reset-gpios", &reset_gpios, 1, ACPI_GPIO_QUIRK_ONLY_GPIOIO },
+	{ "host-wake-gpios", &host_wake_gpios, 1, ACPI_GPIO_QUIRK_ONLY_GPIOIO },
+	{ }
 };
 
 static int intel_probe(struct platform_device *pdev)
-- 
2.28.0