[PATCH 12/13] Bluetooth: btqca: Fix undetected error HCI status in qca_send_reset()

[Zijun Hu <zijun.hu@oss.qualcomm.com>]

qca_send_reset() uses __hci_cmd_sync() which returns an skb but never
reads the HCI status byte from skb->data[0], so a non-zero error status
returned by the controller is silently ignored.

Fix by replacing qca_send_reset() with __hci_reset_sync() which
properly extracts and converts the HCI status byte to a negative errno.

Fixes: 83e81961ff7e ("Bluetooth: btqca: Introduce generic QCA ROME support")
Signed-off-by: Zijun Hu <zijun.hu@oss.qualcomm.com>
---
 drivers/bluetooth/btqca.c | 22 ++--------------------
 1 file changed, 2 insertions(+), 20 deletions(-)

diff --git a/drivers/bluetooth/btqca.c b/drivers/bluetooth/btqca.c
index 04ebe290bc78..875216e15603 100644
--- a/drivers/bluetooth/btqca.c
+++ b/drivers/bluetooth/btqca.c
@@ -190,25 +190,6 @@ static int qca_send_patch_config_cmd(struct hci_dev *hdev)
 	return err;
 }
 
-static int qca_send_reset(struct hci_dev *hdev)
-{
-	struct sk_buff *skb;
-	int err;
-
-	bt_dev_dbg(hdev, "QCA HCI_RESET");
-
-	skb = __hci_cmd_sync(hdev, HCI_OP_RESET, 0, NULL, HCI_INIT_TIMEOUT);
-	if (IS_ERR(skb)) {
-		err = PTR_ERR(skb);
-		bt_dev_err(hdev, "QCA Reset failed (%d)", err);
-		return err;
-	}
-
-	kfree_skb(skb);
-
-	return 0;
-}
-
 static int qca_read_fw_board_id(struct hci_dev *hdev, u16 *bid)
 {
 	u8 cmd;
@@ -990,7 +971,8 @@ int qca_uart_setup(struct hci_dev *hdev, uint8_t baudrate,
 	}
 
 	/* Perform HCI reset */
-	err = qca_send_reset(hdev);
+	bt_dev_dbg(hdev, "QCA HCI_RESET");
+	err = __hci_reset_sync(hdev);
 	if (err < 0) {
 		bt_dev_err(hdev, "QCA Failed to run HCI_RESET (%d)", err);
 		return err;

-- 
2.34.1