Re: [Bluez-devel] cvs software issues

[Dariusz Swiderski <sfires@sfires.net>]

Marcel Holtmann wrote:

>>i just did a cvs co of libs libs2 utils utils2 on a clean system
>>and i have faced following problems:
>>
>>libs2 subdir is missinf the ltmain.sh script which is required by the
>>bootstrap script
> 
> it should create it if it is missing.

apparently it doeas not:
sfires@snoopy:/home/storage/software/cvs/bluez/libs2$ ./bootstrap
configure.in: installing `./install-sh'
configure.in: installing `./mkinstalldirs'
configure.in: installing `./missing'
configure.in:19: installing `./config.guess'
configure.in:19: installing `./config.sub'
configure.in:19: required file `./ltmain.sh' not found
compat/Makefile.am: installing `./depcomp'

im not very goot with automake and autoconf sripts, but in utils and libs
this file, is pulled from cvs, and yes, i have seen the remark in attic ;)

----snip---

> There is no planned coexisting of both version and if libs2 and utils2
> are ready for rollout it will replace the old one.

ok, i can live with this, but what about hcid? its not in utils2

----snip----


> Every program that uses the old library must rewritten to use the new
> one. Especially sdptool, pand and dund. The other big project is writing
> a new sdpd.

so who is doing what, and where can i help?:)

greets
-- 
Maciej 'sfires' Swiderski
---------------------------------------------------
SysAdm | SecOff  | DS14145-RIPE        | DS11-6BONE
193.178.161.0/24 | 3ffe:8010:7:2a::/64 | AS16288
---------------------------------------------------
A mouse is a device used to point at the xterm you want to type in.