From: Dmitry Grebennikov <dmitry.ew@gmail.com>
To: "Bjørn Mork" <bjorn@mork.no>
Cc: linux-bluetooth@vger.kernel.org
Subject: Re: minipcie bluetooth card not detected
Date: Sun, 27 Apr 2014 19:13:06 +0400 [thread overview]
Message-ID: <535D1E82.2080809@gmail.com> (raw)
In-Reply-To: <878uqqdg1p.fsf@nemi.mork.no>
On 27.04.2014 18:04, Bjørn Mork wrote:
> Dmitry Grebennikov <dmitry.ew@gmail.com> writes:
>
>> Hello,
>> I bought new Intel Wireless 7260 ac + BT card recently and installed
>> to my laptop.
>> Wifi works out of box with iwlwifi module + firmware.
>> But the bluetooth adapter isn't recognized at all.
>> What could be the problem with it?
>>
>> The driver for this card is available and installed (btusb with intel
>> bt firmware).
>> lsusb shows no bluetooth adapter (see attachment).
>> Hcitool scan reports that "Device is not available: No such device"
>> Dmesg and lspci outputs are also attached.
> Yes, doesn't look like there is any USB device is detected at all, so
> drivers don't really matter.
>
>> BIOS is upgraded to the last available update.
> Are you 100% sure that the mini-PCIe slot has USB properly wired up?
> Did the previous module include any USB functions, or do you have some
> other USB mini-PCIe module (e.g. a 3G modem) to test it with?
>
> Does the laptop have any other mini-PCIe slots where you can test the
> 7260 module?
>
> My impression is that laptop vendors don't necessarily wire up and test
> stuff they don't use in their own hardware configurations, like USB
> support in a mini-PCIe slot for intended for PCIe-only wlan cards.
>
> I have installed the same 7260 module in two older laptops with mixed
> results regarding the BT function. In both cases, the 7260 module
> replaced an older PCIe-only wlan module. I had to put a piece of tape
> over the D- and D+ pins to avoid the USB part being detected when
> installing in an Acer 3810tz. Otherwise the USB device was detected,
> but reading the device descripor failed - resulting in annoying timeouts
> both when the BIOS ran and later when Linux booted. I have similar
> issues with my Thinkpad X301, but only occasionally on resume. So I
> haven't yet disabled the USB part... I am hoping to fix the annoying
> serialized probing on resume instead, but haven't gotten around to doing
> that yet.
>
> I am pretty sure that both cases are caused by platform issues specific
> to those laptop models, which were never intended to support any USB
> module in those slots.
>
> But based on these results, I would not be surprised if there are
> laptops out there with mini-PCIe slots completely without USB support.
> That's actually better than the Acer variant IMHO, because you don't
> have to figure out how to physically disable the USB pins yourself.
>
>
> Bjørn
Bjørn,
Thanks for your answer.
My previous wireless card was Broadcom BCM94313HMGB, also with both wifi
& bt support.
Bluetooth adapter was always detected.
But there were more pins on BCM card than on Intel (some Intel 7260 pins
have ho wire).
May be the reason is more up-to-date mini-PCIe standard of Intel card,
which is not supported by the PCIe slot of the motherboard ??
Intel have some information about the PCIe standard requirements here:
http://www.intel.com/support/wireless/wlan/sb/CS-031167.htm
If so, what could be the workarounds?
I now there are some adapters from mini-PCIe to SATA or USB.
But I'm not sure if the speed of connection would be the same as via
mini-PCIe...
Dmitry Grebennikov
next parent reply other threads:[~2014-04-27 15:13 UTC|newest]
Thread overview: 2+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <535D03F5.5040100@gmail.com>
[not found] ` <878uqqdg1p.fsf@nemi.mork.no>
2014-04-27 15:13 ` Dmitry Grebennikov [this message]
2014-04-28 11:37 ` minipcie bluetooth card not detected Austin S Hemmelgarn
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=535D1E82.2080809@gmail.com \
--to=dmitry.ew@gmail.com \
--cc=bjorn@mork.no \
--cc=linux-bluetooth@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox