Re: [PATCH] bluetooth: hci_h5: avoid unused variable warnings

[Hans de Goede <hdegoede@redhat.com>]

Hi Arnd,

On 14-08-18 00:04, Arnd Bergmann wrote:
> When CONFIG_BT_HCIUART_RTL is disabled, the hci_h5 driver produces a build
> warning because of an incorrect set of #ifdef guards:
> 
> drivers/bluetooth/hci_h5.c:920:22: error: 'rtl_vnd' defined but not used [-Werror=unused-variable]
> 
> Replacing the #ifdef with an IS_ENABLED() check shuts up the error
> and simplifies the logic.
> 
> Signed-off-by: Arnd Bergmann <arnd@arndb.de>

Hmm, so now you're counting on dead code elimination to remove
references to unavailable symbols. I'm not sure I like this and
since Marcel has also indicated the does not like this fix I
believe we need another fix.

I will write another fix for this.

Regards,

Hans



> ---
>   drivers/bluetooth/hci_h5.c | 10 +++-------
>   1 file changed, 3 insertions(+), 7 deletions(-)
> 
> diff --git a/drivers/bluetooth/hci_h5.c b/drivers/bluetooth/hci_h5.c
> index 8eede1197cd2..b10e64ba0ff4 100644
> --- a/drivers/bluetooth/hci_h5.c
> +++ b/drivers/bluetooth/hci_h5.c
> @@ -841,7 +841,6 @@ static void h5_serdev_remove(struct serdev_device *serdev)
>   	hci_uart_unregister_device(&h5->serdev_hu);
>   }
>   
> -#ifdef CONFIG_BT_HCIUART_RTL
>   static int h5_btrtl_setup(struct h5 *h5)
>   {
>   	struct btrtl_device_info *btrtl_dev;
> @@ -923,24 +922,21 @@ static struct h5_vnd rtl_vnd = {
>   	.close		= h5_btrtl_close,
>   	.acpi_gpio_map	= acpi_btrtl_gpios,
>   };
> -#endif
>   
> -#ifdef CONFIG_ACPI
>   static const struct acpi_device_id h5_acpi_match[] = {
> -#ifdef CONFIG_BT_HCIUART_RTL
>   	{ "OBDA8723", (kernel_ulong_t)&rtl_vnd },
> -#endif
>   	{ },
>   };
>   MODULE_DEVICE_TABLE(acpi, h5_acpi_match);
> -#endif
>   
>   static struct serdev_device_driver h5_serdev_driver = {
>   	.probe = h5_serdev_probe,
>   	.remove = h5_serdev_remove,
>   	.driver = {
>   		.name = "hci_uart_h5",
> -		.acpi_match_table = ACPI_PTR(h5_acpi_match),
> +		.acpi_match_table = (IS_ENABLED(CONFIG_BT_HCIUART_RTL) &&
> +				     IS_ENABLED(CONFIG_ACPI)) ?
> +					h5_acpi_match : 0,
>   	},
>   };
>   
>