Re: [Bluez-users] MS Optical Desktop for bluetooth - Stops working after a time

Bc. Michal Semler
2004-09-17T10:32:36Z

Dne p=E1 17. z=E1=F8=ED 2004 11:57 Daniel Scott napsal(a):
> Hi Marcel,
>
> Thanks for your quick reply,
>
> > show us the output of "hciconfig -a".
>
> Here it is, I see there are quite a few errors, is this the problem?
>
> hci0: Type: USB
> BD Address: 00:50:F2:E4:C2:F5 ACL MTU: 192:8 SCO MTU: 64:8
> UP RUNNING PSCAN ISCAN
> RX bytes:543843 acl:38475 sco:0 events:262 errors:0
> TX bytes:4403 acl:176 sco:0 commands:36 errors:0
> Features: 0xff 0xff 0x0f 0x00 0x00 0x00 0x00 0x00
> Packet type: DM1 DM3 DM5 DH1 DH3 DH5 HV1 HV2 HV3
> Link policy:
> Link mode: SLAVE ACCEPT
> Name: 'SCOTTD'
> Class: 0x000000
> Service Classes: Unspecified
> Device Class: Miscellaneous,
> HCI Ver: 1.1 (0x1) HCI Rev: 0x1f9 LMP Ver: 1.1 (0x1) LMP Subver:
> 0x1f9 Manufacturer: Cambridge Silicon Radio (10)
>
> > > Another minor problem is that I tend to leave my system running
> > > constantly, after ~2 days, the mouse stops working and will not
> > > restart, I have tried replacing the batteries, reconnecting the
> > > devices and restarting the hci0 device (hciconfig hci0 down, hciconfig
> > > hci0 up).
> > >
> > > Would restarting hidd help, I cannot find a 'clean' way to shut it
> > > down and I will try killing it and restarting it the next time that it
> > > happens. The only solution that I currently have is a reboot.
> > >
> > > Thanks for your time, as I said, they are only minor problems so,
> > > don't worry about it too much.
> >
> > In general the mouse should disconnect after 12 minutes and reconnect
> > when it is needed again.
>
> OK, I will investigate this further and try to figure out what is
> happening when the mouse stops working.
>
> Thanks,
>
> Dan

Hi, use this in your hcid.conf:

lp rswitch,hold,sniff,park;
security auto;
pairing multi;

Michal