Hi Ohad
Sorry to break the link.
I am working on arm platform. I want to configure TI's brf6350 on UART.
I read some of the mail on the list. I came to know that hci_ll.c provides support for brf6350.
Is the hci lower level support in kernel enough to drive the chip?

What else I have to do at kernel side to bring UP my brf6350?
Where would I get the brf script file for my chip?

Your response is much awaited.

Thanks and Best regards

Pramod

----- Original Message ----
From: Marcel Holtmann <marcel@holtmann.org>
To: BlueZ development <bluez-devel@lists.sourceforge.net>
Sent: Thursday, 10 July, 2008 6:03:23 PM
Subject: Re: [Bluez-devel] [PATCH] Add support for Texas Instruments' chips

Hi Ohad,

> > please put all the TI code into hciattach_ti.c and then I gonna apply
> > this patch.
>
> I'm gonna have to put some common definitions in hciattach.h then
> (mainly struct uart_t).
>
> Is that ok ?

no. Do the same as I did for hciattach_st.c

Regards

Marcel

-------------------------------------------------------------------------
Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW!
Studies have shown that voting for your favorite open source project,
along with a healthy diet, reduces your potential for chronic lameness
and boredom. Vote Now at http://www.sourceforge.net/community/cca08
_______________________________________________
Bluez-devel mailing list
Bluez-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bluez-devel