[Bluez-devel] Impossible to restart slave

[Mikael Bengtsson <micke_b.b@hotmail.com>]

[-- Attachment #1.1: Type: text/plain, Size: 1281 bytes --]


I'm developing an application which has one master device and three slave devices. The communication links are the following:
 
Slave device 1: RFCOMM and SCO
Slave device 2: RFCOMM and SCO
Slave device 3: RFCOMM
 
If for example slave device 3 should crash or other reason, the master shall automatically try to restart it. But this seems impossible if the other devices are up and running. If I then for example power-off slave device 2, slave device 3 will start immediately. Thereafter, when I power-on slave device 2 again, this device will start too and everything is up and running.
 
I suspect that it is practically impossible to start slave device 3 since there are 2 SCO connections up and running which consumes much bandwidth. Could this be the fact?
 
Is it possible to use hold mode for slave device 2 for a short period of time until slave device 3 starts? What is the BlueZ command for that, I have only seen hci_park_mode.
 
Another solution may be to close down one SCO connection for a short moment and restart it after slave device 3 has started.
 
Are there any other method which can be used?
_________________________________________________________________
Ladda ner hela Windows Live gratis och upptäck fördelarna!
http://get.live.com/ 

[-- Attachment #1.2: Type: text/html, Size: 1603 bytes --]

[-- Attachment #2: Type: text/plain, Size: 278 bytes --]

-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace

[-- Attachment #3: Type: text/plain, Size: 164 bytes --]

_______________________________________________
Bluez-devel mailing list
Bluez-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bluez-devel