Re: [PATCH 1/1] Termination resistor documentation

[Marc Kleine-Budde <mkl@pengutronix.de>]

[-- Attachment #1: Type: text/plain, Size: 1818 bytes --]

On 07.10.2022 06:37:24, Daniel S. Trevitz wrote:
> On Friday, October 7, 2022 3:41:17 AM EDT Marc Kleine-Budde wrote:
> > On 06.10.2022 15:27:50, Daniel S. Trevitz wrote:
> > > Add documentation for how to use and setup the switchable termination
> > > resistor support for the can-controllers.
> > > 
> > > Signed-off-by: Daniel Trevitz <dan@sstrev.com>
> > > ---
> > > 
> > >  Documentation/networking/can.rst | 30 ++++++++++++++++++++++++++++++
> > >  1 file changed, 30 insertions(+)
> > > 
> > > diff --git a/Documentation/networking/can.rst
> > > b/Documentation/networking/can.rst index ebc822e605f5..bb39cfa4c502
> > > 100644
> > > --- a/Documentation/networking/can.rst
> > > +++ b/Documentation/networking/can.rst
> > > @@ -1148,6 +1148,36 @@ tuning on deep embedded systems'. The author is
> > > running a MPC603e> 
> > >  load without any problems ...
> > > 
> > > +Switchable Termination Resistors
> > > +--------------------------------
> > > +
> > > +CAN bus requires a specific impedance across the differential pair,
> > > +typically provided by two 120Ohm resistors on the farthest nodes of
> > > +the bus. Some CAN controllers support activating / deactivating a
> > > +termination resistor(s) to provide the correct impedance.::
> > > +
> > 
> > > +  - Query the available resistances:
> > You need double :: followed by a newline to mark as code.
> This whole section is a code block; :: is up three lines.

Yes, your're right. What about making only the individual commands code?

Marc


-- 
Pengutronix e.K.                 | Marc Kleine-Budde           |
Embedded Linux                   | https://www.pengutronix.de  |
Vertretung West/Dortmund         | Phone: +49-231-2826-924     |
Amtsgericht Hildesheim, HRA 2686 | Fax:   +49-5121-206917-5555 |

[-- Attachment #2: signature.asc --]
[-- Type: application/pgp-signature, Size: 488 bytes --]