Re: [PATCH v5] dt-bindings: net: can: convert ifi_canfd to DT schema

[Krzysztof Kozlowski <krzk@kernel.org>]

On 14/09/2026 04:21, Quchaosheng wrote:
> Convert the IFI CAN-FD controller binding from free-form text to DT
> schema, and reference the common can-controller.yaml schema.
> 
> The driver matches on the "ifi,canfd-1.0" compatible and obtains its
> interrupt through platform_get_irq(), so interrupts is required.
> 
> The example uses the GIC and irq header defines instead of the raw
> numbers from the original text, which keeps the values unchanged
> (GIC_SPI is 0, IRQ_TYPE_NONE is 0 and 1 is IRQ_TYPE_EDGE_RISING). The
> node name is changed from "canfd" to "can" so that it matches the
> $nodename pattern required by can-controller.yaml.
> 
> ---
> v2:
>  - Correct the description: this is a soft IP block typically synthesised
>    into an FPGA or CPLD, not a controller found on Renesas SoCs.
>    Wording now follows the driver's Kconfig entry.
> 
> v3:
>  - Use unevaluatedProperties: false instead of additionalProperties: false.
>    As can-controller.yaml is referenced through allOf, additionalProperties
>    would have rejected properties defined by that common schema, such as
>    termination-gpios and termination-ohms.
> 
> v4:
>  - Use defines instead of raw numbers in the example, and rename the
>    example node from canfd to can. No functional change.
> 
> v5:
>  - Re-send the patch on its own. The v4 posting accidentally included
>    unrelated changes to the xilinx-xadc binding and did not remove
>    ifi_canfd.txt. Only the intended change is present now.

You send this way too many times. Please slow down.

Best regards,
Krzysztof