messages from 2014-09-15 08:02:24 to 2014-10-20 06:14:31 UTC [more...]
[RFC PATCH V3 00/15] CAN: Add rx-fifo support and port flexcan to it
2014-10-20 6:14 UTC (20+ messages)
` [PATCH 01/15] can: flexcan: add documentation about mailbox organizaiton
` [PATCH 02/15] can: flexcan: rename crl2 -> ctrl2
` [PATCH 03/15] can: flexcan: replace open coded mailbox code by proper defines
` [PATCH 04/15] can: flexcan: Re-write receive path to use MB queue instead of FIFO
` [PATCH 05/15] can: dev: add preliminary rx-fifo
` [PATCH 06/15] can: rx-fifo: Increase MB size limit from 32 to 64
` [PATCH 07/15] can: rx-fifo: Change to do controller off-load in interrupt and NAPI poll
` [PATCH 08/15] can: rx-fifo: fix long lines
` [PATCH 09/15] can: rx-fifo: Add can_rx_fifo_reset() function
` [PATCH 10/15] can: rx-fifo: remove obsolete comment
` [PATCH 11/15] can: rx-fifo: Add support for can state tracking and error polling
` [PATCH 12/15] can: flexcan: Add support for RX-FIFO
` [PATCH 13/15] can: rx-fifo: Add support for simple irq offloading
` [PATCH 14/15] can: flexcan: Add MB/Fifo specific column to comment table of IP versions
` [PATCH 15/15] can: flexcan: Re-enable RTR reception support for older flexcan IPs
[PATCH] net: can: esd_usb2: fix memory leak on disconnect
2014-10-18 16:48 UTC (3+ messages)
[PATCH] net: m_can: add CONFIG_HAS_IOMEM dependence
2014-10-18 16:30 UTC (2+ messages)
SocketCAN: Matlab support
2014-10-15 19:05 UTC (5+ messages)
` SocketCAN: Matlab/Simulink embedded coder support
[PATCH 1/1] can: Add support for esd CAN PCIe/402 card
2014-10-13 11:23 UTC
Writing socketCAN module for my own hardware
2014-10-10 8:09 UTC (15+ messages)
[RFC V2 PATCH 1/2] can: rx-fifo: Increase MB size limit from 32 to 64
2014-10-09 12:19 UTC (3+ messages)
` [RFC V2 PATCH 2/2] can: rx-fifo: Change to do controller off-load in interrupt and NAPI poll
[PATCH v5] can: flexcan: Re-write receive path to use MB queue instead of FIFO
2014-10-09 10:37 UTC (29+ messages)
` [RFC PATCH 1/2] can: rx-fifo: Increase MB size limit from 32 to 64
` [RFC PATCH 2/2] can: rx-fifo: Add support for IRQ readout and NAPI poll
randconfig build error with next-20141001, in drivers/i2c/algos/i2c-algo-bit.c
2014-10-07 17:03 UTC (12+ messages)
` Fwd: "
[RESEND] [PATCH] net: CAN: at91_can.c: decrease likelyhood of RX overruns
2014-10-07 11:36 UTC (11+ messages)
[PATCH] drivers/net/can/m_can/Kconfig: Let CAN_M_CAN depend on HAS_IOMEM
2014-10-04 11:49 UTC (3+ messages)
[PATCH] drivers/net/can/Kconfig: Let CAN_AT91 depend on HAS_IOMEM
2014-10-02 14:01 UTC
[PATCH v2 0/3] net: can: Use syscon regmap for TI specific RAMINIT register
2014-10-01 11:11 UTC (30+ messages)
` [PATCH v2 1/3] can: c_can_platform: Fix c_can_hw_raminit_ti() and add timeout
` [PATCH v2 2/3] net: can: c_can: Add syscon/regmap RAMINIT mechanism
Calling can_free_echo_skb() from interrupt causes WARN
2014-09-30 4:21 UTC
AW: ESD CAN-USB/2 Linux Mint 16 kernel 3.11
2014-09-29 14:05 UTC (2+ messages)
[PATCH v4] can: flexcan: Re-write receive path to use MB queue instead of FIFO
2014-09-29 13:24 UTC (6+ messages)
[PATCH v2 4/4] can: sja1000: Consolidate and unify state change handling
2014-09-26 18:26 UTC
[PATCH v2 3/4] can: mscan: Consolidate and unify state change handling
2014-09-26 18:25 UTC
[PATCH v2 2/4] can: flexcan: Consolidate and unify state change handling
2014-09-26 18:25 UTC
[PATCH v2 1/4] can: dev: Consolidate and unify state change handling
2014-09-26 18:25 UTC
用了一次你就会觉得是最好的短信发送平台 1i
2014-09-26 5:56 UTC
ESD CAN-USB/2 Linux Mint 16 kernel 3.11
2014-09-26 5:35 UTC (2+ messages)
` AW: "
[PATCH 2/4] Consolidate and unify state change handling
2014-09-24 6:28 UTC (8+ messages)
[PATCH] can: flexcan: make use of FLEXCAN_MB_CODE_
2014-09-23 13:25 UTC
[PATCH 1/4] Consolidate and unify state change handling
2014-09-21 15:27 UTC (5+ messages)
pull-request: can 2014-09-18
2014-09-19 21:34 UTC (10+ messages)
` [PATCH 1/8] can: c_can_platform: fix parameters of c_can_hw_raminit_ti()
` [PATCH 2/8] can: peak_pci: add PCI ID definition pcie card variant
` [PATCH 3/8] can: flexcan: mark TX mailbox as TX_INACTIVE
` [PATCH 4/8] can: flexcan: correctly initialize mailboxes
` [PATCH 5/8] can: flexcan: implement workaround for errata ERR005829
` [PATCH 6/8] can: flexcan: put TX mailbox into TX_INACTIVE mode after tx-complete
` [PATCH 7/8] can: flexcan: increase FLEXCAN_MCR_MAXMB() macro to 7 bits
` [PATCH 8/8] can: at91_can: add missing prepare and unprepare of the clock
[PATCH v2 1/4] Consolidate and unify state change handling
2014-09-18 17:25 UTC
[PATCH 0/4] Consolidate and unify state change handling
2014-09-18 16:25 UTC
[PATCH 2/4] Consolidate and unify state change handling
2014-09-18 16:38 UTC
[PATCH 0/4] Consolidate and unify state change handling
2014-09-18 16:37 UTC
[PATCH 4/4] Consolidate and unify state change handling
2014-09-18 16:26 UTC
[PATCH 3/4] Consolidate and unify state change handling
2014-09-18 16:26 UTC
RFC: [PATCH v2] can: flexcan: Implement errata ERR005829
2014-09-18 13:50 UTC (6+ messages)
[PATCHv2] can: at91_can: prepare and unprepare the clock
2014-09-17 20:16 UTC (3+ messages)
[PATCH] can: at91_can: prepare and unprepare the clock
2014-09-17 10:11 UTC (2+ messages)
[PATCH] can: at91_can: prepare and unprepare the clock
2014-09-17 9:05 UTC
[PATCH v4 1/5] can: flexcan: mark TX mailbox as TX_INACTIVE
2014-09-16 15:28 UTC (7+ messages)
` [PATCH v4 2/5] can: flexcan: correctly initialize mailboxes
` [PATCH v4 3/5] can: flexcan: implement workaround for errata ERR005829
` [PATCH v4 4/5] can: flexcan: put TX mailbox into TX_INACTIVE mode after tx-complete
` [PATCH v4 5/5] can: flexcan: increase FLEXCAN_MCR_MAXMB() macro to 7 bits
RFC: Improve and consolidate error state change
2014-09-16 14:50 UTC (3+ messages)
[PATCH] net: can: usb: peak_usb: pcan_usb_core.c: Cleaning up missing null-terminate in conjunction with strncpy
2014-09-16 14:09 UTC (7+ messages)
[PATCH can] peak_pci: add PCI ID definition pcie card variant
2014-09-16 14:01 UTC (4+ messages)
[PATCH v5 0/2] Adding support for CAN busses via SPI interface
2014-09-16 13:01 UTC (3+ messages)
[PATCH] net: can: sja1000: peak_pcmcia.c: Cleaning up missing null-terminate in conjunction with strncpy
2014-09-15 8:02 UTC (2+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).