[PATCH v4 6/6] ARM: sun8i: a83t: Switch to CCU device tree binding macros

[Chen-Yu Tsai <wens@csie.org>]

Now that the CCU device tree binding headers have been merged, we can
use the properly named macros in the device tree, instead of raw
numbers.

Signed-off-by: Chen-Yu Tsai <wens@csie.org>
---
 arch/arm/boot/dts/sun8i-a83t.dtsi | 9 ++++++---
 1 file changed, 6 insertions(+), 3 deletions(-)

diff --git a/arch/arm/boot/dts/sun8i-a83t.dtsi b/arch/arm/boot/dts/sun8i-a83t.dtsi
index e12dd7170b8f..050d3e347740 100644
--- a/arch/arm/boot/dts/sun8i-a83t.dtsi
+++ b/arch/arm/boot/dts/sun8i-a83t.dtsi
@@ -44,6 +44,9 @@
 
 #include <dt-bindings/interrupt-controller/arm-gic.h>
 
+#include <dt-bindings/clock/sun8i-a83t-ccu.h>
+#include <dt-bindings/reset/sun8i-a83t-ccu.h>
+
 / {
 	interrupt-parent = <&gic>;
 	#address-cells = <1>;
@@ -178,7 +181,7 @@
 				     <GIC_SPI 17 IRQ_TYPE_LEVEL_HIGH>,
 				     <GIC_SPI 100 IRQ_TYPE_LEVEL_HIGH>;
 			reg = <0x01c20800 0x400>;
-			clocks = <&ccu 45>, <&osc24M>, <&osc16Md512>;
+			clocks = <&ccu CLK_BUS_PIO>, <&osc24M>, <&osc16Md512>;
 			clock-names = "apb", "hosc", "losc";
 			gpio-controller;
 			interrupt-controller;
@@ -225,8 +228,8 @@
 			interrupts = <GIC_SPI 0 IRQ_TYPE_LEVEL_HIGH>;
 			reg-shift = <2>;
 			reg-io-width = <4>;
-			clocks = <&ccu 53>;
-			resets = <&ccu 40>;
+			clocks = <&ccu CLK_BUS_UART0>;
+			resets = <&ccu RST_BUS_UART0>;
 			status = "disabled";
 		};
 
-- 
2.11.0