[PATCH net-next 03/12] dt-bindings: net: dwmac-sun8i: Clean up clock delay chain descriptions

[Chen-Yu Tsai <wens@csie.org>]

The clock delay chains found in the glue layer for dwmac-sun8i are only
used with RGMII PHYs. They are not intended for non-RGMII PHYs, such as
MII external PHYs or the internal PHY. Also, a recent SoC has a smaller
range of possible values for the delay chain.

This patch reformats the delay chain section of the device tree binding
to make it clear that the delay chains only apply to RGMII PHYs, and
make it easier to add the R40-specific bits later.

Signed-off-by: Chen-Yu Tsai <wens@csie.org>
---
 Documentation/devicetree/bindings/net/dwmac-sun8i.txt | 11 +++++++----
 1 file changed, 7 insertions(+), 4 deletions(-)

diff --git a/Documentation/devicetree/bindings/net/dwmac-sun8i.txt b/Documentation/devicetree/bindings/net/dwmac-sun8i.txt
index 3d6d5fa0c4d5..b8a3028d6c30 100644
--- a/Documentation/devicetree/bindings/net/dwmac-sun8i.txt
+++ b/Documentation/devicetree/bindings/net/dwmac-sun8i.txt
@@ -28,10 +28,13 @@ Required properties:
   - allwinner,sun8i-a83t-system-controller
 
 Optional properties:
-- allwinner,tx-delay-ps: TX clock delay chain value in ps. Range value is 0-700. Default is 0)
-- allwinner,rx-delay-ps: RX clock delay chain value in ps. Range value is 0-3100. Default is 0)
-Both delay properties need to be a multiple of 100. They control the delay for
-external PHY.
+- allwinner,tx-delay-ps: TX clock delay chain value in ps.
+			 Range is 0-700. Default is 0.
+- allwinner,rx-delay-ps: RX clock delay chain value in ps.
+			 Range is 0-3100. Default is 0.
+Both delay properties need to be a multiple of 100. They control the
+clock delay for external RGMII PHY. They are do apply to the internal
+PHY or external non-RGMII PHYs.
 
 Optional properties for the following compatibles:
   - "allwinner,sun8i-h3-emac",
-- 
2.16.2