Re: [PATCH v6 2/6] ARM: imx6: register pm_power_off handler if "fsl,pmic-stby-poweroff" is set

[Russell King - ARM Linux <linux@armlinux.org.uk>]

On Mon, Mar 05, 2018 at 11:25:19AM +0100, Oleksij Rempel wrote:
> One of the Freescale recommended sequences for power off with external
> PMIC is the following:
> ...
> 3.  SoC is programming PMIC for power off when standby is asserted.
> 4.  In CCM STOP mode, Standby is asserted, PMIC gates SoC supplies.
> 
> See:
> http://www.nxp.com/assets/documents/data/en/reference-manuals/IMX6DQRM.pdf
> page 5083
> 
> This patch implements step 4. of this sequence.
> 
> Signed-off-by: Oleksij Rempel <o.rempel@pengutronix.de>
> ---
>  arch/arm/mach-imx/pm-imx6.c | 25 +++++++++++++++++++++++++
>  1 file changed, 25 insertions(+)
> 
> diff --git a/arch/arm/mach-imx/pm-imx6.c b/arch/arm/mach-imx/pm-imx6.c
> index ecdf071653d4..24689260a2a5 100644
> --- a/arch/arm/mach-imx/pm-imx6.c
> +++ b/arch/arm/mach-imx/pm-imx6.c
> @@ -604,6 +604,28 @@ static void __init imx6_pm_common_init(const struct imx6_pm_socdata
>  				   IMX6Q_GPR1_GINT);
>  }
>  
> +static void imx6_pm_stby_poweroff(void)
> +{
> +	imx6_set_lpm(STOP_POWER_OFF);
> +	cpu_suspend(0, imx6q_suspend_finish);

Do you actually need to save the processor state etc here - the request
is after all to power down the system and not to suspend.  Would calling
imx6q_suspend_finish() directly work (and hence simplify the code) ?

-- 
RMK's Patch system: http://www.armlinux.org.uk/developer/patches/
FTTC broadband for 0.8mile line in suburbia: sync at 8.8Mbps down 630kbps up
According to speedtest.net: 8.21Mbps down 510kbps up