[PATCH 5/7] ARM: dts: wpcm450: Add clock controller node

["Jonathan Neuschäfer" <j.neuschaefer@gmx.net>]

This declares the clock controller and the necessary 48 Mhz reference
clock in the WPCM450 device. Switching devices over to the clock
controller is intentionally done in a separate patch to give time for
the clock controller driver to land.

Signed-off-by: Jonathan Neuschäfer <j.neuschaefer@gmx.net>
---
 arch/arm/boot/dts/nuvoton-wpcm450.dtsi | 17 +++++++++++++++++
 1 file changed, 17 insertions(+)

diff --git a/arch/arm/boot/dts/nuvoton-wpcm450.dtsi b/arch/arm/boot/dts/nuvoton-wpcm450.dtsi
index 1c63ab14c4383..62d70fda7b520 100644
--- a/arch/arm/boot/dts/nuvoton-wpcm450.dtsi
+++ b/arch/arm/boot/dts/nuvoton-wpcm450.dtsi
@@ -39,6 +39,14 @@ clk24m: clock-24mhz {
 		#clock-cells = <0>;
 	};

+	refclk: clock-48mhz {
+		/* 48 MHz reference oscillator */
+		compatible = "fixed-clock";
+		clock-output-names = "refclk";
+		clock-frequency = <48000000>;
+		#clock-cells = <0>;
+	};
+
 	soc {
 		compatible = "simple-bus";
 		#address-cells = <1>;
@@ -51,6 +59,15 @@ gcr: syscon@b0000000 {
 			reg = <0xb0000000 0x200>;
 		};

+		clk: clock-controller@b0000200 {
+			compatible = "nuvoton,wpcm450-clk";
+			reg = <0xb0000200 0x100>;
+			clocks = <&refclk>;
+			clock-names = "refclk";
+			#clock-cells = <1>;
+			#reset-cells = <1>;
+		};
+
 		serial0: serial@b8000000 {
 			compatible = "nuvoton,wpcm450-uart";
 			reg = <0xb8000000 0x20>;
--
2.35.1