messages from 2026-07-31 03:25:01 to 2026-07-31 08:14:09 UTC [more...]
[PATCH v11 00/11] clk / reset: realtek: Add RTD1625 clock and reset support
2026-07-31 8:13 UTC (8+ messages)
` [PATCH v11 01/11] dt-bindings: clock: Add Realtek RTD1625 Clock & Reset Controller
` [PATCH v11 08/11] clk: realtek: Add support for MMC-tuned PLL clocks
[PATCH v3 0/8] clk: clocking-wizard: Add static-config clock provider support
2026-07-31 7:20 UTC (9+ messages)
` [PATCH v3 1/8] dt-bindings: clock: clocking-wizard: Add static-config mode support
` [PATCH v3 2/8] clk: clocking-wizard: Do not map the memory for static-config
` [PATCH v3 3/8] clk: clocking-wizard: Move clk_in1 acquisition before static-config check
` [PATCH v3 4/8] clk: clocking-wizard: Add static-config clock provider support
` [PATCH v3 5/8] clk: clocking-wizard: Skip s_axi_aclk for static-config
` [PATCH v3 6/8] clk: clocking-wizard: Use dev_err_probe() when mapping registers
` [PATCH v3 7/8] clk: clocking-wizard: Fix division by zero and unbounded register write
` [PATCH v3 8/8] clk: clocking-wizard: Use separate notifier_block for each clock
[PATCH 00/10] Ambarella CV75 SoC minimal bring-up
2026-07-31 6:38 UTC (3+ messages)
` [PATCH 08/10] serial: ambarella: add Ambarella UART driver
[PATCH 00/13] Add clock support for Exynos8855 SoC
2026-07-31 6:29 UTC (7+ messages)
` [PATCH 01/13] clk: samsung: clk-pll: Add supoprt for pll_4313
` [PATCH 03/13] clk: samsung: exynos8855: add block top and peric clock support
[PATCH v2 0/2] clk: qcom: Add GPUCC and GXCLK support for Hawi
2026-07-31 5:53 UTC (3+ messages)
` [PATCH v2 1/2] dt-bindings: clock: qcom: Add Hawi GPU clock controllers
` [PATCH v2 2/2] clk: qcom: Add support for Hawi GPUCC
[PATCH v1] clk: qcom: Drop inclusions of <linux/mod_devicetable.h>
2026-07-31 3:24 UTC (2+ messages)
[PATCH v4 0/5] clk: qcom: Introduce initial clock controllers for Maili SoC
2026-07-31 3:24 UTC (2+ messages)
` (subset) "
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox