messages from 2026-10-16 04:27:37 to 2026-10-16 14:13:00 UTC [more...]
[PATCH 0/4] Add Qualcomm's IPQ9650 APSS Clock Driver Support
2026-10-16 14:12 UTC (7+ messages)
` [PATCH 1/4] interconnect: icc-clk: support N:1 master-to-slave topology
` [PATCH 2/4] clk: qcom: clk-alpha-pll: Skip Zonda PLL configuration if already enabled
` [PATCH 4/4] clk: qcom: apss-ipq9650: Add IPQ9650 APSS clock controller driver
[PATCH 0/4] clk: qcom: Add support for Glymur AV1E clock controller
2026-10-16 13:37 UTC (5+ messages)
` [PATCH 1/4] clk: qcom: gcc-glymur: Mark GCC AV1E AHB and XO clocks as critical
` [PATCH 4/4] arm64: dts: qcom: glymur: Add support for AV1E clock controller
[PATCH RFC 0/3] clk: meson: Refactor PLL pre-divider as a divider clock
2026-10-16 13:24 UTC (5+ messages)
[PATCH] clk: qcom: gcc-qcs615: Add additional frequencies for GP clocks
2026-10-16 11:26 UTC (2+ messages)
[PATCH] clk: samsung: exynos5-subcmu: Defer probe until power domains are available
2026-10-16 11:21 UTC (2+ messages)
[PATCH 0/2] clk: qcom: gcc-ipq5018: stop UBI0 clocks from reclocking their parents
2026-10-16 9:06 UTC (5+ messages)
` [PATCH 1/2] clk: qcom: gcc-ipq5018: drop CLK_SET_RATE_PARENT from ubi0_axi_clk_src
` [PATCH 2/2] clk: qcom: gcc-ipq5018: drop CLK_SET_RATE_PARENT from UBI0 NoC branches
[PATCH v13 00/13] ZTE zx297520v3 clock bindings and driver
2026-10-16 7:20 UTC (4+ messages)
` [PATCH v13 04/13] mfd: zx297520v3: Add a clock and reset MFD driver
[PATCH] clk: qcom: gcc-glymur: Use PWRSTS_RET_ON flag for USB GDSCs
2026-10-16 6:28 UTC
[PATCH v11 0/5] Add initial support for Qualcomm SM7250 SoC
2026-10-16 4:41 UTC (8+ messages)
` [PATCH v11 2/5] clk: qcom: Add Global Clock Controller (GCC) driver for SM7250
` [PATCH v11 3/5] dt-bindings: firmware: qcom,scm: Document SM7250 SCM
` [PATCH v11 4/5] dt-bindings: cpufreq: qcom-hw: Document SM7250 cpufreq hardware
` [PATCH v11 5/5] arm64: dts: qcom: Add SM7250 devicetree file
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox