Re: [PATCH v9 3/3] x86/snp: Convert shared memory back to private on kexec

["Kalra, Ashish" <ashish.kalra@amd.com>]

Hello Boris,

On 6/24/2024 10:59 PM, Borislav Petkov wrote:
> On Mon, Jun 24, 2024 at 03:57:34PM -0500, Kalra, Ashish wrote:
>> ...  Hence, added simple static functions make_pte_private() and
>> set_pte_enc() to make use of the more optimized snp_set_memory_private() to
>> use the GHCB instead of the MSR protocol. Additionally, make_pte_private()
>> adds check for GHCB addresses during unshare_all_memory() loop.
> IOW, what you're saying is: "Boris, what you're asking can't be done."
>
> Well, what *you're* asking - for me to maintain crap - can't be done either.
> So this will stay where it is.
>
> Unless you make a genuine effort and refactor the code...

There is an issue with calling __set_clr_pte_enc() here for the _bss_decrypted section being made private again,

when calling __set_clr_pte_enc() on _bss_decrypted section pages, clflush_cache_range() will fail as __va()

on this physical range fails as the bss_decrypted section pages are not in kernel direct map.

Hence, clflush_cache_range() in __set_clr_pte_enc() causes an implicit page state change which is not resolved as below and causes fatal guest exit :

qemu-system-x86_64: warning: memory fault: GPA 0x4000000 size 0x1000 flags 0x8 kvm_convert_memory start 0x4000000 size 0x1000 shared_to_private

...

KVM: unknown exit reason 24 EAX=00000000 EBX=00000000 ECX=00000000 EDX=00000000 ESI=00000000 EDI=00000000 EBP=00000000 ESP=00000000 EIP=00000000 EFL=00000002 [-------] CPL=0 II=0 A20=1 SMM=0 HLT=0

...

This is the reason why i had to pass the vaddr to set_pte_enc(), added here for kexec code, so that i can use it for clflush_cache_range().

So for specific cases such as this, where we can't call __set_clr_pte_enc() on _bss_decrypted section, we probably need a separate set_pte_enc().

Thanks, Ashish