* multi interface device
@ 2017-02-05 11:17 Giuseppe Lippolis
0 siblings, 0 replies; only message in thread
From: Giuseppe Lippolis @ 2017-02-05 11:17 UTC (permalink / raw)
To: devicetree-u79uwXL29TY76Z2rM5mHXA
Hi All,
I'm going to investigate for a proslic device driver.
The proslic is a chip able to drive a regular phone.
It has 2 main interface, one spi interface used for control, one pcm
interface used to stream the audio.
In addition one irq is available.
Suppose that my soc have one spi controller (to connect the ctrl port), one
pcm controller (to connect the pcm port) and one gpio where to connect the
irq line, how shall I write the corresponding DT?
How then the init/probe phase for the module shall proceed?
Thanks.
Bye.
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2017-02-05 11:17 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2017-02-05 11:17 multi interface device Giuseppe Lippolis
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).