Re: [PATCH v4 1/2] mtd: rawnand: meson: discard the common MMC sub clock framework

[Liang Yang <liang.yang@amlogic.com>]

Hi Neil,


On 2022/4/4 20:40, Neil Armstrong wrote:
> [ EXTERNAL EMAIL ]
> 
> Hi,
> 
> On 02/04/2022 09:49, Liang Yang wrote:
>> EMMC and NAND have the same clock control register named 
>> 'SD_EMMC_CLOCK' which is
>> defined in EMMC port internally. bit0~5 of 'SD_EMMC_CLOCK' is the 
>> divider and
>> bit6~7 is the mux for fix pll and xtal.A common MMC and NAND sub-clock 
>> has been
>> implemented and can be used by the eMMC and NAND controller (which are 
>> mutually
>> exclusive anyway). Let's use this new clock.
>>
>> Signed-off-by: Liang Yang <liang.yang@amlogic.com>
>> ---
>>   drivers/mtd/nand/raw/meson_nand.c | 89 +++++++++++++++----------------
>>   1 file changed, 42 insertions(+), 47 deletions(-)
>>
>> diff --git a/drivers/mtd/nand/raw/meson_nand.c 
>> b/drivers/mtd/nand/raw/meson_nand.c
>> index ac3be92872d0..1b1a9407fb2f 100644
>> --- a/drivers/mtd/nand/raw/meson_nand.c
>> +++ b/drivers/mtd/nand/raw/meson_nand.c
>> @@ -10,6 +10,7 @@
>>   #include <linux/dma-mapping.h>
>>   #include <linux/interrupt.h>
>>   #include <linux/clk.h>
>> +#include <linux/clk-provider.h>
>>   #include <linux/mtd/rawnand.h>
>>   #include <linux/mtd/mtd.h>
>>   #include <linux/mfd/syscon.h>
>> @@ -19,6 +20,7 @@
>>   #include <linux/iopoll.h>
>>   #include <linux/of.h>
>>   #include <linux/of_device.h>
>> +#include <linux/of_address.h>
>>   #include <linux/sched/task_stack.h>
>>   #define NFC_REG_CMD        0x00
>> @@ -104,6 +106,9 @@
>>   #define PER_INFO_BYTE        8
>> +#define CLK_DIV_SHIFT        0
>> +#define CLK_DIV_WIDTH        6
>> +
>>   struct meson_nfc_nand_chip {
>>       struct list_head node;
>>       struct nand_chip nand;
>> @@ -151,15 +156,15 @@ struct meson_nfc {
>>       struct nand_controller controller;
>>       struct clk *core_clk;
>>       struct clk *device_clk;
>> -    struct clk *phase_tx;
>> -    struct clk *phase_rx;
>> +    struct clk *nand_clk;
>> +    struct clk_divider nand_divider;
>>       unsigned long clk_rate;
>>       u32 bus_timing;
>>       struct device *dev;
>>       void __iomem *reg_base;
>> -    struct regmap *reg_clk;
>> +    void __iomem *sd_emmc_clock;
> 
> The name could still be reg_clk, even if not a regmap anymore.

ok, i will do it.
> 
>>       struct completion completion;
>>       struct list_head chips;
>>       const struct meson_nfc_data *data;
>> @@ -235,7 +240,7 @@ static void meson_nfc_select_chip(struct nand_chip 
>> *nand, int chip)
>>       nfc->timing.tbers_max = meson_chip->tbers_max;
>>       if (nfc->clk_rate != meson_chip->clk_rate) {
>> -        ret = clk_set_rate(nfc->device_clk, meson_chip->clk_rate);
>> +        ret = clk_set_rate(nfc->nand_clk, meson_chip->clk_rate);
>>           if (ret) {
>>               dev_err(nfc->dev, "failed to set clock rate\n");
>>               return;
>> @@ -406,7 +411,6 @@ static int meson_nfc_queue_rb(struct meson_nfc 
>> *nfc, int timeout_ms)
>>       cmd = NFC_CMD_RB | NFC_CMD_RB_INT
>>           | nfc->param.chip_select | nfc->timing.tbers_max;
>>       writel(cmd, nfc->reg_base + NFC_REG_CMD);
>> -
>>       ret = wait_for_completion_timeout(&nfc->completion,
>>                         msecs_to_jiffies(timeout_ms));
>>       if (ret == 0)
>> @@ -985,9 +989,11 @@ static const struct mtd_ooblayout_ops 
>> meson_ooblayout_ops = {
>>       .free = meson_ooblayout_free,
>>   };
>> +struct clk_parent_data nfc_divider_parent_data[1];
> 
> This should be in the meson_nfc_clk_init() function, not global

ok.

> 
>>   static int meson_nfc_clk_init(struct meson_nfc *nfc)
>>   {
>>       int ret;
>> +    struct clk_init_data init = {0};
>>       /* request core clock */
>>       nfc->core_clk = devm_clk_get(nfc->dev, "core");
>> @@ -1002,21 +1008,26 @@ static int meson_nfc_clk_init(struct meson_nfc 
>> *nfc)
>>           return PTR_ERR(nfc->device_clk);
>>       }
>> -    nfc->phase_tx = devm_clk_get(nfc->dev, "tx");
>> -    if (IS_ERR(nfc->phase_tx)) {
>> -        dev_err(nfc->dev, "failed to get TX clk\n");
>> -        return PTR_ERR(nfc->phase_tx);
>> -    }
>> -
>> -    nfc->phase_rx = devm_clk_get(nfc->dev, "rx");
>> -    if (IS_ERR(nfc->phase_rx)) {
>> -        dev_err(nfc->dev, "failed to get RX clk\n");
>> -        return PTR_ERR(nfc->phase_rx);
>> -    }
>> +    init.name = devm_kstrdup(nfc->dev, "nfc#div", GFP_KERNEL);
> 
> name = devm_kasprintf(nfc->dev, GFP_KERNEL, "%s#div", dev_name(dev));
> 
> would be better.

ok, thanks.

> 
>> +    init.ops = &clk_divider_ops;
>> +    nfc_divider_parent_data[0].fw_name = "device";
>> +    init.parent_data = nfc_divider_parent_data;
>> +    init.num_parents = 1;
>> +    nfc->nand_divider.reg = nfc->sd_emmc_clock;
>> +    nfc->nand_divider.shift = CLK_DIV_SHIFT;
>> +    nfc->nand_divider.width = CLK_DIV_WIDTH;
>> +    nfc->nand_divider.hw.init = &init;
>> +    nfc->nand_divider.flags = CLK_DIVIDER_ONE_BASED |
>> +                  CLK_DIVIDER_ROUND_CLOSEST |
>> +                  CLK_DIVIDER_ALLOW_ZERO;
>> +
>> +    nfc->nand_clk = devm_clk_register(nfc->dev, &nfc->nand_divider.hw);
>> +    if (IS_ERR(nfc->nand_clk))
>> +        return PTR_ERR(nfc->nand_clk);
>>       /* init SD_EMMC_CLOCK to sane defaults w/min clock rate */
>> -    regmap_update_bits(nfc->reg_clk,
>> -               0, CLK_SELECT_NAND, CLK_SELECT_NAND);
>> +    writel(CLK_SELECT_NAND | readl(nfc->sd_emmc_clock),
>> +           nfc->sd_emmc_clock);
>>       ret = clk_prepare_enable(nfc->core_clk);
>>       if (ret) {
>> @@ -1030,29 +1041,21 @@ static int meson_nfc_clk_init(struct meson_nfc 
>> *nfc)
>>           goto err_device_clk;
>>       }
>> -    ret = clk_prepare_enable(nfc->phase_tx);
>> +    ret = clk_prepare_enable(nfc->nand_clk);
>>       if (ret) {
>> -        dev_err(nfc->dev, "failed to enable TX clock\n");
>> -        goto err_phase_tx;
>> +        dev_err(nfc->dev, "pre enable NFC divider fail\n");
>> +        goto err_nand_clk;
>>       }
>> -    ret = clk_prepare_enable(nfc->phase_rx);
>> -    if (ret) {
>> -        dev_err(nfc->dev, "failed to enable RX clock\n");
>> -        goto err_phase_rx;
>> -    }
>> -
>> -    ret = clk_set_rate(nfc->device_clk, 24000000);
>> +    ret = clk_set_rate(nfc->nand_clk, 24000000);
>>       if (ret)
>> -        goto err_disable_rx;
>> +        goto err_disable_clk;
>>       return 0;
>> -err_disable_rx:
>> -    clk_disable_unprepare(nfc->phase_rx);
>> -err_phase_rx:
>> -    clk_disable_unprepare(nfc->phase_tx);
>> -err_phase_tx:
>> +err_disable_clk:
>> +    clk_disable_unprepare(nfc->nand_clk);
>> +err_nand_clk:
>>       clk_disable_unprepare(nfc->device_clk);
>>   err_device_clk:
>>       clk_disable_unprepare(nfc->core_clk);
>> @@ -1061,8 +1064,7 @@ static int meson_nfc_clk_init(struct meson_nfc 
>> *nfc)
>>   static void meson_nfc_disable_clk(struct meson_nfc *nfc)
>>   {
>> -    clk_disable_unprepare(nfc->phase_rx);
>> -    clk_disable_unprepare(nfc->phase_tx);
>> +    clk_disable_unprepare(nfc->nand_clk);
>>       clk_disable_unprepare(nfc->device_clk);
>>       clk_disable_unprepare(nfc->core_clk);
>>   }
>> @@ -1374,7 +1376,6 @@ static int meson_nfc_probe(struct 
>> platform_device *pdev)
>>   {
>>       struct device *dev = &pdev->dev;
>>       struct meson_nfc *nfc;
>> -    struct resource *res;
>>       int ret, irq;
>>       nfc = devm_kzalloc(dev, sizeof(*nfc), GFP_KERNEL);
>> @@ -1388,21 +1389,15 @@ static int meson_nfc_probe(struct 
>> platform_device *pdev)
>>       nand_controller_init(&nfc->controller);
>>       INIT_LIST_HEAD(&nfc->chips);
>>       init_completion(&nfc->completion);
>> -
>>       nfc->dev = dev;
>> -    res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
>> -    nfc->reg_base = devm_ioremap_resource(dev, res);
>> +    nfc->reg_base = devm_platform_ioremap_resource_byname(pdev, "nfc");
>>       if (IS_ERR(nfc->reg_base))
>>           return PTR_ERR(nfc->reg_base);
>> -    nfc->reg_clk =
>> -        syscon_regmap_lookup_by_phandle(dev->of_node,
>> -                        "amlogic,mmc-syscon");
>> -    if (IS_ERR(nfc->reg_clk)) {
>> -        dev_err(dev, "Failed to lookup clock base\n");
>> -        return PTR_ERR(nfc->reg_clk);
>> -    }
>> +    nfc->sd_emmc_clock = devm_platform_ioremap_resource_byname(pdev, 
>> "emmc");
>> +    if (IS_ERR(nfc->sd_emmc_clock))
>> +        return PTR_ERR(nfc->sd_emmc_clock);
>>       irq = platform_get_irq(pdev, 0);
>>       if (irq < 0)
> 
> Thanks,
> Neil
> 
> .