Re: [PATCH v3 07/12] arm64: dts: qcom: pm8350c: Enable BCL sensor node

[Manaf Meethalavalappu Pallikunhi <manaf.pallikunhi@oss.qualcomm.com>]

Hi Abel,

On 9/29/2026 6:45 PM, Abel Vesa wrote:
> On 26-09-29 18:39:39, Manaf Meethalavalappu Pallikunhi wrote:
>> Add Battery Current Limiting (BCL) hardware monitor node for pm8350c
>> PMIC. The BCL monitors battery voltage and current, providing hardware
>> interrupts when configurable thresholds are violated.
>>
>> Signed-off-by: Manaf Meethalavalappu Pallikunhi <manaf.pallikunhi@oss.qualcomm.com>
>> ---
>>   arch/arm64/boot/dts/qcom/pm8350c.dtsi | 12 ++++++++++++
>>   1 file changed, 12 insertions(+)
>>
>> diff --git a/arch/arm64/boot/dts/qcom/pm8350c.dtsi b/arch/arm64/boot/dts/qcom/pm8350c.dtsi
>> index 1a24e6439e36..52b5fc1ef9a3 100644
>> --- a/arch/arm64/boot/dts/qcom/pm8350c.dtsi
>> +++ b/arch/arm64/boot/dts/qcom/pm8350c.dtsi
>> @@ -20,6 +20,17 @@ pm8350c_temp_alarm: temp-alarm@a00 {
>>   			#thermal-sensor-cells = <0>;
>>   		};
>>   
>> +		sensor@4700 {
>> +			compatible = "qcom,pm8350c-bcl";
>> +			reg = <0x4700>;
>> +			interrupts = <0x2 0x47 0x0 IRQ_TYPE_EDGE_RISING>,
>> +				     <0x2 0x47 0x1 IRQ_TYPE_EDGE_RISING>,
>> +				     <0x2 0x47 0x2 IRQ_TYPE_EDGE_RISING>;
>> +			interrupt-names = "max-min",
>> +					  "critical",
>> +					  "emergency";
>> +		};
>> +
>>   		pm8350c_gpios: gpio@8800 {
>>   			compatible = "qcom,pm8350c-gpio", "qcom,spmi-gpio";
>>   			reg = <0x8800>;
>> @@ -41,6 +52,7 @@ pm8350c_pwm: pwm {
>>   			#pwm-cells = <2>;
>>   			status = "disabled";
>>   		};
>> +
> 
> Drop this new empty line.

Thanks for review, will fix it in next revision.

Thanks,
Manaf>
>>   	};
>>   };
>>   
>>
>> -- 
>> 2.43.0
>>