Re: [PATCH v4 2/2] Documentation: dt: iio: add st_lsm6dsx sensor device binding

[Jonathan Cameron <jic23-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>]

On 10/01/17 21:55, Lorenzo Bianconi wrote:
> Acked-by: Rob Herring <robh-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>
> Signed-off-by: Lorenzo Bianconi <lorenzo.bianconi-qxv4g6HH51o@public.gmane.org>
Applied.

Thanks,

Jonathan
> ---
>  .../devicetree/bindings/iio/imu/st_lsm6dsx.txt     | 24 ++++++++++++++++++++++
>  1 file changed, 24 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/iio/imu/st_lsm6dsx.txt
> 
> diff --git a/Documentation/devicetree/bindings/iio/imu/st_lsm6dsx.txt b/Documentation/devicetree/bindings/iio/imu/st_lsm6dsx.txt
> new file mode 100644
> index 0000000..ed3cdac
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/iio/imu/st_lsm6dsx.txt
> @@ -0,0 +1,24 @@
> +* ST_LSM6DSx driver for STM 6-axis (acc + gyro) imu Mems sensors
> +
> +Required properties:
> +- compatible: must be one of:
> +  "st,lsm6ds3"
> +  "st,lsm6dsm"
> +- reg: i2c address of the sensor / spi cs line
> +
> +Optional properties:
> +- interrupt-parent: should be the phandle for the interrupt controller
> +- interrupts: interrupt mapping for IRQ. It should be configured with
> +  flags IRQ_TYPE_LEVEL_HIGH or IRQ_TYPE_EDGE_RISING.
> +
> +  Refer to interrupt-controller/interrupts.txt for generic interrupt
> +  client node bindings.
> +
> +Example:
> +
> +lsm6dsm@6b {
> +	compatible = "st,lsm6dsm";
> +	reg = <0x6b>;
> +	interrupt-parent = <&gpio0>;
> +	interrupts = <0 IRQ_TYPE_EDGE_RISING>;
> +};
>