Re: [PATCH v2 6/8] ARM: dts: sun8i: a83t: Move mmc1 pinctrl setting to dtsi file

[icenowy-h8G6r0blFSE@public.gmane.org]

在 2017-10-19 14:48，Chen-Yu Tsai 写道：
> On Wed, Oct 18, 2017 at 11:00 PM, Joonas Kylmälä 
> <joonas.kylmala-X3B1VOXEql0@public.gmane.org> wrote:
>> Hi,
>> 
>> Chen-Yu Tsai:
>>> mmc1 only has 1 possible pinmux setting.
>> 
>> What if someone is using the MMC with bus width 1 and then using the
>> remaining 3 pins for something else?
> 
> I would very much like to see such a design. Currently the devices
> we see all follow Allwinner's reference design, with only minor
> modifications. As such, mmc1 is used exclusively for connecting
> SDIO-based WiFi modules.
> 
> If such a radical(?) design is done, the vendor can always add
> a "mmc1-1bit-pins" setting and override the default.

I think this kind of thing happened on A13 -- the MMC2 of A13 is
8-bit, but Lichee Pi One wires it to a SD card slot (4-bit); then
the remaining 4 data lines are wired out as GPIO. (Lichee Pi's
do not like obeying reference design ;-) )

But I think a MMC/SDIO device under 1-bit mode is too slow that
maybe no one will use such a setup.

> 
> ChenYu

-- 
You received this message because you are subscribed to the Google Groups "linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send an email to linux-sunxi+unsubscribe-/JYPxA39Uh5TLH3MbocFF+G/Ez6ZCGd0@public.gmane.org
For more options, visit https://groups.google.com/d/optout.