From: Jean-Christophe PLAGNIOL-VILLARD <plagnioj-sclMFOaUSTBWk0Htik3J/w@public.gmane.org>
To: linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org
Cc: spi-devel-general-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org,
devicetree-discuss-uLR06cmDAlY/bJ5BZ2RsiQ@public.gmane.org,
Jean-Christophe PLAGNIOL-VILLARD
<plagnioj-sclMFOaUSTBWk0Htik3J/w@public.gmane.org>
Subject: [PATCH 3/3] spi/atmel: add DT support
Date: Thu, 9 Feb 2012 17:14:37 +0100 [thread overview]
Message-ID: <1328804077-6121-3-git-send-email-plagnioj@jcrosoft.com> (raw)
In-Reply-To: <1328804077-6121-1-git-send-email-plagnioj-sclMFOaUSTBWk0Htik3J/w@public.gmane.org>
the atmel_spi use only gpio for chip select
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj-sclMFOaUSTBWk0Htik3J/w@public.gmane.org>
Cc: devicetree-discuss-uLR06cmDAlY/bJ5BZ2RsiQ@public.gmane.org
Cc: spi-devel-general-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org
---
.../devicetree/bindings/spi/spi_atmel.txt | 6 ++++++
drivers/spi/spi-atmel.c | 12 +++++++++++-
2 files changed, 17 insertions(+), 1 deletions(-)
create mode 100644 Documentation/devicetree/bindings/spi/spi_atmel.txt
diff --git a/Documentation/devicetree/bindings/spi/spi_atmel.txt b/Documentation/devicetree/bindings/spi/spi_atmel.txt
new file mode 100644
index 0000000..7ec3d8d
--- /dev/null
+++ b/Documentation/devicetree/bindings/spi/spi_atmel.txt
@@ -0,0 +1,6 @@
+Atmel SPI device
+
+Required properties:
+- compatible : should be "atmel,at91rm9200-spi".
+- reg: Address and length of the register set for the device
+- interrupts: Should contain macb interrupt
diff --git a/drivers/spi/spi-atmel.c b/drivers/spi/spi-atmel.c
index 16d6a83..7bcd11f 100644
--- a/drivers/spi/spi-atmel.c
+++ b/drivers/spi/spi-atmel.c
@@ -19,6 +19,7 @@
#include <linux/interrupt.h>
#include <linux/spi/spi.h>
#include <linux/slab.h>
+#include <linux/of.h>
#include <asm/io.h>
#include <mach/board.h>
@@ -938,7 +939,7 @@ static int __devinit atmel_spi_probe(struct platform_device *pdev)
master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_CS_HIGH;
master->bus_num = pdev->id;
- master->num_chipselect = 4;
+ master->num_chipselect = master->dev.of_node ? 0 : 4;
master->setup = atmel_spi_setup;
master->transfer = atmel_spi_transfer;
master->cleanup = atmel_spi_cleanup;
@@ -1064,11 +1065,20 @@ static int atmel_spi_resume(struct platform_device *pdev)
#define atmel_spi_resume NULL
#endif
+#if defined(CONFIG_OF)
+static const struct of_device_id atmel_spi_dt_ids[] = {
+ { .compatible = "atmel,at91rm9200-spi" },
+ { /* sentinel */ }
+};
+
+MODULE_DEVICE_TABLE(of, atmel_spi_dt_ids);
+#endif
static struct platform_driver atmel_spi_driver = {
.driver = {
.name = "atmel_spi",
.owner = THIS_MODULE,
+ .of_match_table = of_match_ptr(atmel_spi_dt_ids),
},
.suspend = atmel_spi_suspend,
.resume = atmel_spi_resume,
--
1.7.7
------------------------------------------------------------------------------
Virtualization & Cloud Management Using Capacity Planning
Cloud computing makes use of virtualization - but cloud computing
also focuses on allowing computing to be delivered as a service.
http://www.accelacomm.com/jaw/sfnl/114/51521223/
next prev parent reply other threads:[~2012-02-09 16:14 UTC|newest]
Thread overview: 7+ messages / expand[flat|nested] mbox.gz Atom feed top
2012-02-09 16:14 [PATCH 1/3] spi: move master of_node init to spi_alloc_master Jean-Christophe PLAGNIOL-VILLARD
[not found] ` <1328804077-6121-1-git-send-email-plagnioj-sclMFOaUSTBWk0Htik3J/w@public.gmane.org>
2012-02-09 16:14 ` [PATCH 2/3] of_spi: add generic binding support to specify ncs gpio Jean-Christophe PLAGNIOL-VILLARD
2012-02-14 4:24 ` Jean-Christophe PLAGNIOL-VILLARD
[not found] ` <20120214042419.GG3378-RQcB7r2h9QmfDR2tN2SG5Ni2O/JbrIOy@public.gmane.org>
2012-02-20 9:56 ` Jean-Christophe PLAGNIOL-VILLARD
2012-02-09 16:14 ` Jean-Christophe PLAGNIOL-VILLARD [this message]
[not found] ` <1328804077-6121-3-git-send-email-plagnioj-sclMFOaUSTBWk0Htik3J/w@public.gmane.org>
2012-03-03 2:39 ` [PATCH 3/3] spi/atmel: add DT support Grant Likely
2012-03-03 3:46 ` Jean-Christophe PLAGNIOL-VILLARD
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1328804077-6121-3-git-send-email-plagnioj@jcrosoft.com \
--to=plagnioj-sclmfoaustbwk0htik3j/w@public.gmane.org \
--cc=devicetree-discuss-uLR06cmDAlY/bJ5BZ2RsiQ@public.gmane.org \
--cc=linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org \
--cc=spi-devel-general-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).