Re: How to get the irq flags from the dts file

[Wei Ni <wni-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org>]

On Thu, 2012-08-09 at 20:09 +0800, Arend van Spriel wrote:
> On 08/09/2012 12:43 PM, Wei Ni wrote:
> > Hi, all
> > I'm working on tegra wlan upstream issue.
> > The tegra board use the Broadcom 4329 as wlan device, and the driver is
> > the brcmfmac. 
> > 
> > This wlan driver support out-band-interrupt (OOB), I want to add DT
> > support to use this OOB.
> > I can add following lines in the dts file to create platform device and
> > pass the interrupt resource to the driver.
> > 
> > wlan {
> >         compatible = "broadcome, brcmf_sdio_pd";
> 
> I don't know the DT syntax, but I assume broadcome should be broadcom,
> right? ;-)

Sorry, it's my typo, it should be broadcom.

> 
> >         interrupt-parten = <&gpio>;
> >         interrupts = <144, 0x04>; /* IRQF_TRIGGER_HIGH */
> > };
> > 
> > In the wlan driver, it will use platform_get_resource() to get the
> > res->irq, res->flags, the irq number is right, but the flags will be
> > IORESOURCE_IRQ, not the 0x04 (IRQF_TRIGGER_HIGH).
> > The wlan driver wish this flags include the IRQF_TRGGER_* information,
> > and it will use this flags to configure other hw settings. If it is
> > wrong, the wlan can't work.
> > 
> > I checked drivers/of/irq.c, in function of_irq_to_resource(), it will
> > set r->flags = IORESOURCE_IRQ directly, not read the flags from the dtb
> > file. And I didn't find any of_xx api to get this flags.
> > 
> > How can I get this flags, does anyone has suggestion?
> 
> I did a quick search in the kernel and there are a number of platform
> drivers that seem to expect the IRQF_TRIGGER_* info by using (res->flags
> & IRQF_TRIGGER_MASK) and to determine IRQF_SHARED as well.
> 
> Gr. AvS
>