Re: [PATCH v2 1/8] dt: describe base reset signal binding

[Philipp Zabel <p.zabel-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>]

Hi Shawn,

Am Sonntag, den 17.02.2013, 21:05 +0800 schrieb Shawn Guo:
> On Wed, Feb 13, 2013 at 06:34:25PM +0100, Philipp Zabel wrote:
> > From: Stephen Warren <swarren-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org>
> > 
> > This binding is intended to represent the hardware reset signals present
> > internally in most IC (SoC, FPGA, ...) designs.
> > It consists of a binding for a reset controller device (provider), and a
> > pair of properties, "resets" and "reset-names", to link a device node
> > (consumer) to its reset controller via phandle, similarly to the clock
> > and interrupt bindings.
> > 
> > The reset controller has all information necessary to reset the consumer
> > device. That could be provided via device tree, or it could be implemented
> > in hardware.
> > The aim is to enable device drivers to request a framework API to issue a
> > reset simply by providing their struct device pointer as the most common
> > case.
> > 
> > Signed-off-by: Stephen Warren <swarren-DDmLM1+adcrQT0dZR+AlfA@public.gmane.org>
> > Signed-off-by: Philipp Zabel <p.zabel-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>
> 
> Reviewed-by: Shawn Guo <shawn.guo-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org>

thank you for the review. I have made the changes you suggested and will
resend, rebased onto next-20130219.

regards
Philipp