From mboxrd@z Thu Jan 1 00:00:00 1970 From: Javier Martinez Canillas Subject: [PATCH 1/1] gpio: omap: dts: Move interrupt-controller from #interrupt-cells description Date: Mon, 4 Mar 2013 19:35:57 +0100 Message-ID: <1362422157-32196-1-git-send-email-javier.martinez@collabora.co.uk> Return-path: Sender: linux-omap-owner@vger.kernel.org To: Grant Likely Cc: Rob Landley , Benoit Cousson , Stephen Warren , Jon Hunter , devicetree-discuss@lists.ozlabs.org, linux-omap , Javier Martinez Canillas List-Id: devicetree@vger.kernel.org The binding documentation for the OMAP GPIO controller has the description for the "#interrupt-cells" property after the "interrupt-controller" definition. This is confusing so is better to move "interrupt-controller" after the "#interrupt-cells" description. Reported-by: Stephen Warren Signed-off-by: Javier Martinez Canillas --- .../devicetree/bindings/gpio/gpio-omap.txt | 2 +- 1 files changed, 1 insertions(+), 1 deletions(-) diff --git a/Documentation/devicetree/bindings/gpio/gpio-omap.txt b/Documentation/devicetree/bindings/gpio/gpio-omap.txt index bff51a2..8b9914c 100644 --- a/Documentation/devicetree/bindings/gpio/gpio-omap.txt +++ b/Documentation/devicetree/bindings/gpio/gpio-omap.txt @@ -10,7 +10,6 @@ Required properties: - second cell is used to specify optional parameters (unused) - gpio-controller : Marks the device node as a GPIO controller. - #interrupt-cells : Should be 2. -- interrupt-controller: Mark the device node as an interrupt controller The first cell is the GPIO number. The second cell is used to specify flags: bits[3:0] trigger type and level flags: @@ -18,6 +17,7 @@ Required properties: 2 = high-to-low edge triggered. 4 = active high level-sensitive. 8 = active low level-sensitive. +- interrupt-controller: Mark the device node as an interrupt controller. OMAP specific properties: - ti,hwmods: Name of the hwmod associated to the GPIO: -- 1.7.7.6